Berning-TF12-pre-sch维修电路原理图.pdf

《Berning-TF12-pre-sch维修电路原理图.pdf》由会员分享，可在线阅读，更多相关《Berning-TF12-pre-sch维修电路原理图.pdf（4页珍藏版）》请在收音机爱好者资料库上搜索。

1、 The failure prone parts in the TF-12 are the optical encoder volume control, 1Meg resistor in the mute time out (located on the power supply board), the HER602 diodes in the power supply, 470 F capacitors associated with these diodes, socket for 7805 voltage regulator IC on digital board (soldered

2、in in later versions), and foil connections under tube sockets on the Teflon circuit board. The failure of the optical encoder involves oxidation of the solder connections due to improper assembly by US Digital, in that the leads were cut too short. These controls can be pried open and these connect

3、ions resoldered. Alternatively, a new control can be ordered from US Digital. Go to products tab, and then incremental encoders, and then look for the SP-16. It is recommended that the HER602 diodes be replaced with the MUR820 (was Motorola, now ON Semiconductors), and that the 470F capacitors be up

4、graded to 1000F high- frequency types. Loud pops, particularly in the phono section when the tubes are moved indicates broken foil on the circuit board. Thin foil traces should be bridged with light-gauge bare wire, even though the breaks can not be seen. Audio noise is sometimes caused by noisy 15K, 2W plate resistors on the 6DJ8/6922 tubes. RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库