Cambridge-AR30II-rec-sm维修电路原理图.pdf

《Cambridge-AR30II-rec-sm维修电路原理图.pdf》由会员分享，可在线阅读，更多相关《Cambridge-AR30II-rec-sm维修电路原理图.pdf（43页珍藏版）》请在收音机爱好者资料库上搜索。

1、 Gallery Court Hankey Place London SE1 4BB UK Tel: +44 (0)20 7940 2200 Fax: +44 (0)20 7940 2233 AR30 V2 Issue Date: February 2011 _ SERVICE MANUAL _ Technical specifications AR30 v2 specifications Amplifier section Power output 40 watts per channel (into 8) THD 0.05% 20Hz-20kHz 80% max power 80dB A

2、weighted Line input impedances 47kohms (CD, DVD, Aux and MP3 inputs) Tone controls +/-12dB 100Hz and 10kHz (shelving) Headphone output 3.5mm stereo mini jack 32-600ohm headphones recommended Tuners Bands AM (530-1710kHz) FM/VHF (87.5MHz to 108MHz) Aerial inputs FM 75ohms, Coaxial. AM 300 ohms wire l

3、oop/single wire. Signal to noise 80dB typical (DAB) 60dB typical (FM) Distortion 0.01% 1kHz 2V rms o/p (DAB) 0.2% 1kHz 50kHz deviation (FM mono) 0.6% 1kHz 50kHz deviation (FM stereo) DD30 docking station for iPod THD 0.009% 1kHz S/N ratio -80dB re 2V output. General Trigger Outputs 3x 12V 30mA, 3.5m

4、m jack, Tip positive. Corresponding to CD, DVD and Aux inputs Power Supply AR30-EU: 230V AC 50Hz (UK/EU) AR30-CU: 115V AC 60Hz (CU/US) Max. power consumption 300W Standby power consumption 1W Dimensions 270 x 67 x 285mm (WxHxD) Weight 4.0kg (8.6lbs) 1 RadioFans.CN 收音机爱 好者资料库 TABLEOFCONTENTS Specific

5、ations_1 TableofContents_2 FrontPanelControls_34 RearPanelConnections_56 SafetyInstructions_710 ExplodedDiagram_11 FrontPanelAssembly_12 PartsTable_13 VFDSchematic_14 DisplayTop_15 DisplayBottom_16 AmpSchematic_17 AmpTop_18 AmpBottom_19 PowerSchematic_20 PowerLayout Top_ _ _ _21 Power Layout Bottom_

6、22 BillofMaterials_2337 ICDetails_3843 2 RadioFans.CN 收音机爱 好者资料库 Front panel controls 1. Standby/On Switches the unit between a low power standby mode (indicated by dim power LED) and on (indicated by bright power LED). Standby is a low power mode where the power consumption is less than 3 Watts. Th

7、e unit may be left in standby mode when not in use. 2. Infrared sensor Receive IR commands from the supplied remote control. A clear unobstructed line of sight between the remote control and the sensor is required. 3. Phones Allows for the connection of stereo headphones with a 3.5mm jack plug. Head

8、phones with an impedance of between 32 and 600 ohms are recommended. Note: Plugging in headphones will automatically mute the loudspeaker output. 4. Source Press to cycle through the available input sources such as tuner, MP3, CD, DVD and aux inputs. 5. Skip/Scan Sonata AR30 v2 In preset mode, steps

9、 up or down through the user-stored presets. In manual mode, steps through the frequency band, for fine-tuning. If button is held, the unit will search for the next station with a strong signal. Sonata DR30 In preset mode, steps up or down through the user-stored presets. In FM manual mode, steps th

10、rough the frequency band, for fine-tuning. If button is held, the unit will search for the next station with a strong signal. In DAB manual mode, browse through the available stations. Note: When MP3 input is selected, and an iPod is inserted into the attached DD30 dock, the ? ? buttons will skip th

11、rough the track lists. Press and holding the ? ? buttons will scan through the current track. When Preset Mode is activated, the unit will automatically tune to the first available preset. 6. Display Used to display information such as station name and program type for DAB broadcasts and FM broadcas

12、ts with RDS/RBDS. Also provides feedback on volume, source, and various other data. 7. Band Press to switch between FM, AM and SIRIUS bands (if a SIRIUS module is attached) on AR30, or 3 Front panel controls DAB and FM bands on DR30. 8. Info Changes the display mode to allow the user to view differe

13、nt information. In tuner mode, data varies depending on the type of broadcast, and signal quality. When in a non-tuner mode, pressing the Info button will briefly display the clock time, before returning to show the current source. 9. Select/Mode In tuner mode, pressing once will toggle the tuning m

14、ode between preset and manual. In presets mode, the unit will automatically tune to the first available preset in the band. Alternatively, you may press and hold to store the current station in the preset bank. Use the ? ? keys or rotate the Volume control to select the preset location where you wis

15、h to store the preset, and press Select/Mode again to confirm. 10. MP3 Input This source input allows you to connect a portable audio device such as an MP3 player directly into the front of the unit using the 3.5mm stereo-jack (labelled MP3 In). Select the MP3 input source using the Source button or

16、 direct MP3 button on the remote to listen to your portable audio device. Note: Plugging a source into the front panel MP3 input overrides the DD30 docking station (which is also selected by selecting the MP3 source via the remote control or front panel Source button). Simply remove the jack from th

17、e front panel socket to automatically re-enable the DD30 docking station as the MP3 source. There is no need to unplug the DD30 docking station whilst using the front panel MP3 input and it will continue to charge a docked iPod as usual. 11. Volume control Use to increase or decrease the level of th

18、e sound from the outputs of the unit. This controls the volume level of the loudspeakers, subwoofer and headphones. It does not affect the Rec Out output. It is also used to change the value of the selected settings in audio setup and advanced setup menus. Press once to enter the audio setup menu. P

19、ress and hold to enter the advanced setup menu. See later section in this manual. 4 Rear panel connections 1. Power On/Off Switches the unit on or off. 2. AC power socket Once you have completed all connections to the amplifier, plug the AC power cable into an appropriate mains socket and turn the u

20、nit on. Your unit is now ready for use. 3. Loudspeaker terminals Connect to loudspeakers with an impedance of 8ohms. For best audio performance we recommend using speakers from Cambridge Audios Sirocco range which have been designed in conjunction with the Sonata series. Please consult your dealer f

21、or details. 4. AM/FM antenna Tuner aerial connections for picking up radio signals. Refer to Connections section of this manual. For permanent use, outdoor AM/FM aerials are highly recommended. 5. SIRIUS socket (US version only) SIRIUS satellite radio adaptor connection (requires subscription and a

22、suitable module). Consult your dealer for more information. 6. DD30 dock connector Connection for the supplied DD30 iPod dock. The docking station has a proprietary connector and will only work with the Cambridge DD30 docking station supplied. iPod compatibility The DD30 docking station for iPod is

23、able to communicate with and control the following iPod models: iPod nano (1st, 2nd, 3rd and 4th generation) iPod (4th generation, photo and 5th generation) iPod classic iPod touch (1st and 2nd generation) 5 Rear panel connections 7. Trigger Out Sonata AR30/DR30 produces trigger outputs that can be

24、used to control the On/Standby status of other connected Cambridge Audio Sonata range source components (such as the CD30 CD player and DV30 DVD player) if desired. See Connections section. 8. Sub In/Out Connect Sub Out to the input of an active subwoofer. If your subwoofer has 2 inputs (i.e. left a

25、nd right), then connect this terminal to the left input terminal (usually coloured white). The Sub In socket is for use with a Sonata DV30 DVD player. 9. Rec Out Connect to the recording input of a tape deck, a portable music player, CD recorder input etc. 10. Audio Inputs These inputs are suitable

26、for any line level source equipment such as the audio outputs of Sonata DV30 DVD player, Sonata CD30 CD player, satellite/cable receiver etc. 11. DAB/FM Aerial input The Sonata DR30 has an F-type screw connection aerial for both FM and DAB signals (a temporary aerial is supplied). Extend the aerial

27、lead and move around until you get the best reception. For permanent use, outdoor DAB and FM aerials are highly recommended. 6 Important safety instructions For your own safety please read the following important safety instructions carefully before attempting to connect this unit to the mains power

28、 supply. They will also enable you to get the best performance from and prolong the life of the unit: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any

29、 ventilation openings. Install in accordance with the manufacturers instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plu

30、g. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsole

31、te outlet. 10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use with only the cart, stand, tripod, bracket, or table spe

32、cified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. Refer all servicing to qualified service

33、personnel. Servicing is required when the apparatus has been damaged in any way, such as the power-supply adaptor having been damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped

34、. WARNING To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. The unit must be installed in a manner that makes disconnection of the mains

35、 plug from the mains socket outlet (or appliance connector from the rear of the unit) possible. Where the mains plug is used as the disconnect device, the disconnect device shall remain readily operable. Only use the mains cord supplied with this unit. Please ensure there is ample ventilation. We re

36、commend that you do not place the unit in an enclosed space; if you wish to place the unit on a shelf, use the top shelf to allow maximum ventilation. Do not put any objects on top of this unit. Do not situate it on a rug or other soft surface and do not obstruct any air inlets or outlet grilles. Do

37、 not cover the ventilation grilles with items such as newspapers, tablecloths, curtains, etc. This unit must not be used near water or exposed to dripping or splashing water or other liquids. No objects filled with liquid, such as vases, shall be placed on the unit. 7 Important safety instructions T

38、he lightning flash with the arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of un-insulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point withi

39、n an equilateral triangle is intended to alert the user to the presence of important operating and maintenance instructions in the service literature relevant to this appliance. The symbol on this product indicates that it is of CLASS II (double insulated) construction. WEEE symbol The crossed-out w

40、heeled bin is the European Union symbol for indicating separate collection for electrical and electronic equipment. This product contains electrical and electronic equipment which should be reused, recycled or recovered and should not be disposed of with unsorted regular waste. Please return the uni

41、t or contact the authorised dealer from whom you purchased this product for more information. CE mark This product complies with European Low Voltage (2006/95/EC) and Electromagnetic Compatibility (89/336/EEC) Directives when used and installed according to this instruction manual. For continued com

42、pliance only Cambridge Audio accessories should be used with this product and servicing must be referred to qualified service personnel. C-Tick mark This product meets the Australian Communications Authoritys Radio communications and EMC requirements. Ross Test Stamp This product meets Russian elect

43、ronic safety approvals. FCC regulations NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT. This equipment has been tested and found to comply wit

44、h the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

45、 in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the i