Classe-M700S-pwr-sm维修电路原理图.pdf

上传人:cc518 文档编号:100877 上传时间:2020-11-04 格式:PDF 页数:7 大小:1.44MB
下载 相关 举报
Classe-M700S-pwr-sm维修电路原理图.pdf_第1页
第1页 / 共7页
Classe-M700S-pwr-sm维修电路原理图.pdf_第2页
第2页 / 共7页
Classe-M700S-pwr-sm维修电路原理图.pdf_第3页
第3页 / 共7页
亲,该文档总共7页,到这儿已超出免费预览范围,如果喜欢就下载吧!
资源描述

《Classe-M700S-pwr-sm维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Classe-M700S-pwr-sm维修电路原理图.pdf(7页珍藏版)》请在收音机爱好者资料库上搜索。

1、RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 Class Model M-700/S-700 Bias and Offset Adjustment Ensure that the amplifier is assembled and functioning properly. Disconnect all input and output connections. Power up the amplifier. Adjust the A.C. line voltage to 120V. For each channel: Bias Adjust

2、ment: Connect the common lead of your digital multimeter to the pad labeled P17. Measure the voltages on the NPN emitter pads labeled P4, P5, P6, P7, P15, P16. Measure the voltages on the PNP emitter pads (see diagrams). These 12 pads must be constantly monitored during the first hour after the ampl

3、ifier has been turned on. The transistors are matched for gain and therefore should have similar emitter voltages. The difference between the absolute values of the voltages on each emitter pad should never be allowed to exceed 6mV. When the amplifier is cold, the measurements should be approximatel

4、y 14mV 5mV. Use trimpot R13 to adjust the bias. Final adjustment for each channel: Adjust the bias so that the average of the six NPN emitter readings equals 22mV. Offset Adjustment: Connect the common lead of your digital multimeter to the pad labeled P17. Measure the voltage on pad P11. When the a

5、mp is cold, this measurement should be approximately 100mV. Use trimpot R4 to adjust the offset. Let the amp idle for 6 to 8 hours at a room temperature of 22 Celsius (72 Fahrenheit). The line voltage should be steady at 120V. The heatsinks will reach a final temperature of approximately 47 Celsius (117 Fahrenheit). Final adjustment for each channel: Adjust the offset so that it is between 0mV and +10mV. NOTE: There is some overshoot when making bias and offset adjustments. Turn the trimpots to 1 revolution at a time and let the amp settle for 15 to 20 minutes after each adjustment.

展开阅读全文
相关资源
猜你喜欢
相关搜索
资源标签

当前位置:首页 > 功放/音响/收扩 > Classe

copyright@ 2008-2025 收音机爱好者资料库 版权所有
备案编号:鄂ICP备16009402-5号