Electrocompaniet-MC2-riaa-sch维修电路原理图.pdf

上传人:cc518 文档编号:102541 上传时间:2020-11-07 格式:PDF 页数:3 大小:587.26KB
下载 相关 举报
Electrocompaniet-MC2-riaa-sch维修电路原理图.pdf_第1页
第1页 / 共3页
Electrocompaniet-MC2-riaa-sch维修电路原理图.pdf_第2页
第2页 / 共3页
Electrocompaniet-MC2-riaa-sch维修电路原理图.pdf_第3页
第3页 / 共3页
亲,该文档总共3页,全部预览完了,如果喜欢就下载吧!
资源描述

《Electrocompaniet-MC2-riaa-sch维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《Electrocompaniet-MC2-riaa-sch维修电路原理图.pdf(3页珍藏版)》请在收音机爱好者资料库上搜索。

1、RadioFans.CN 收音机爱 好者资料库 E L E C T R O C O M P A N I E T AS Electrocompaniet MC-2 Moving Coil Interface The Electrocompaniet MC-2 is a unique step-up device. It will make extremely low output moving coil cartridges compatiole with any preamp. There are basically two parts of the MC-2 design, each con

2、tributing to what is theoretically an ideal moving coil-amplification interface. It not only responds to the dynamic impedance demands of moving coil cartridges when a musical signal is introduced, but the design also gives special consideration to the dramatic influences of noise and distortion on

3、the amplification of the extremely minute signal that comes from a moving coil cartridge. The Electrocompaniet MC-2 provides a more exact and complete moving coil-amplification interface than high-gain preamps and voltage-gain step-up devices. The first part of the moving-coil interface circuit desi

4、gn is a current-sensing device. The interface senses the current coming from the moving coil and automatically adjusts to its impedance characteristics. It is a dynamic interface, and is constantly adjusting to the demands of any moving-coil cartridge as it responds to musical signals. Voltage-gain

5、step-ups are designed to operate with a nominal static impedance measured under laboratory conditions that will provide the flattest frequency response for a given moving-coil cartridge; however, when an actual musical signal is introduced these devices tend to damp full dynamic and frequency respon

6、se. The dynamic current-sensing capabilities of the Electrocompaniet MC-2 do not damp cartridge performance as is the case with step-ups that require cartridge loading with resistors. The second part of the circuitry is a user-adjustable feedback loop. The appropriate setting provides the degree of

7、feedback that will result in the lowest noise and distortion for a particular moving-coil cartridge. The importance of eliminating as much noise and distortion as possible at the crucial input stage where the signal is very small was only recently discovered. As a result of years of trial-and-error

8、experimenting with the effect of closed-loop feedback on sonic performance, the designer of Electrocompaniet electronics found that a relatively small amount of feedback in the first stage of amplification results in far more dramatic sonic improvement than larger amounts of feedback elsewhere in th

9、e signal path. RadioFans.CN 收音机爱 好者资料库 Although there is only 6 db of feedback throughout the entire range of the 16-setting potentiometer in each channel of the MC-2, adjustments of only one or two positions result in obvious sonic differences. Most moving coil cartridges perform best with settings

10、 between 0 and 7, with 0 representing the least amount of feedback. The user may prefer that the dealership preset the MC-2 according to Electrocompaniets recommendations, or the user may want to experiment with the settings. The potentiometers- that control the feedback loop in each channel are rea

11、dily accessible through openings on the bottom plate of the device. Electrocompaniet has experimented with a number of moving coil cartridges with the MC-2 and has determined that the following ranges are most suitable: Koetsu 1-3 Dynavector 2-4 Asak 3-5 EMT 3-5 AC-2 4-6 Alpha-1 3-5 The exact settin

12、g within the recommended range is dependent upon a number of variables such as the sonic character of other components in the system and the acoustic interaction of the listening environment. In general, a setting that is too low results in audible distortion. The listener can readily recognize that

13、 bass and high frequencies are soft and lacking in dynamic impact. A setting that is too high results in increased low-level transistor noise. Bass will be very tight, but high frequencies oegin to sound unnaturally hard and sharp. Finding the right setting is a matter of starting with a low setting

14、 and increasing feedback until the listener recognizes unnaturally hard and sharp high frequencies. Turning each potentiometer back one or two notches should result in an optimum amount of feedback where noise and distortion are at a minimum. Musical intruments and performers will become more focuse

15、d on an amazingly dimensional soundstage. Tonal quality is accurate and natural. Many listeners have commented that the sense of electronics in their audio systems actually seems to disappear, and they are closer to the vitality of the performance as captured on the source. Mailing address: P.O.BOX 92, l473Skdrer, Norway. Office address: Stremsveien 72, l473Skdrer, Norway Tel:(02) 706410. Telex: 18225otegr. Bank: Den norske Creditbank 7104.05.06092 RadioFans.CN 收音机爱 好者资料库

展开阅读全文
相关资源
猜你喜欢
相关搜索
资源标签

当前位置:首页 > 功放/音响/收扩 > ElectroHarmonix

copyright@ 2008-2025 收音机爱好者资料库 版权所有
备案编号:鄂ICP备16009402-5号