《HarmanKardon-AVR20-avr-sb维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《HarmanKardon-AVR20-avr-sb维修电路原理图.pdf(3页珍藏版)》请在收音机爱好者资料库上搜索。
1、 harman/kardon Service Bulletin Service bulletin # 9706 November 1997 Warranty labor rate: MINOR repair To: All harman/kardon Service Centers Models: AVR 10/20/25/3250; AVI 100/150/200 Subject: Remote Control has stopped working In the event you receive a complaint about a remote control that has st
2、opped working, perform the following tests: 1) Remove the batteries and confirm they are not weak or defective (battery voltage should be 1.4 volts or more). Replace batteries if necessary; both batteries in remote control should be replaced. 2) Point the remote towards the corresponding receiver/am
3、plifier and confirm the remote control functions operate as intended. 3) If Remote Control still doesnt work: Remove batteries, and with an alligator clip lead or other jumper wire, short the positive and negative tabs inside the control together. (See drawing) This short will drain any remaining ch
4、arge from the capacitors in the remote control and re-set the microprocessor. 4) Re-insert batteries and test the functions as per item (2) above. NOTE: This procedure may also work for other h/k model remote controls not listed above. harman/kardon Incorporated 250 Crossways Park Drive, Woodbury Ne
5、w York 11797 (516) 496-3400 RadioFans.CN 收音机爱 好者资料库 harman/kardon Service Bulletin Service bulletin # 9502 - February 1995Warranty labor rate: MAJOR repair To: All harman/kardon Service Centers Models:AVR-20/AVI-150 Surround receiver/amplifier Subject: Low impedance protect circuit, intermittend shu
6、t down. The power rating for the AVR-20 and AVI-150 is 60 Watts into 8 Ohms. The AVR-20 and AVI-150 protection circuits will not activate until the loudspeaker impedance drops below 4 Ohms. During transients in certain CD program material, the instantaneous impedance of some loudspeakers with impeda
7、nce ratings of “8 Ohms” can drop well below 4 Ohms. As result, the low impedance protection circuit will be activated. In the event you receive from a consumer one of these products with the complaint “unit shuts down intermittendly” change the components indicated in the table below. After the chan
8、ge, confirm the idling current by measuring the voltage between the emitters of the output transistors. The test points are TP1/TP2 and TP3/TP4. The voltage reading should stabilize at 26 mV after the unit has been switched on for at least 15 minutes. If needed, adjust idling current potentiometers
9、VR251L/VR251R until you read 26 mV. ChangeFromToPart # Driver Transistor Q214L/214R2SC2690(A)2SC4883(A)2028307101 Driver Transistor Q215L/Q215R2SA1220(A)2SA1859(A)2028007101 Power Transistor Q216L/Q216R 2SC3181 (O)2SC3182(O)2028307101 Power Transistor Q217L/Q217R 2SA1264(O)2SA1265(O)2028007101 Resis
10、tor R244L/244R1.8kOhm1.8kOhm 1/8 W GD05182160 Resistor R243L/R243R2.2 kOhm2.0 kOhm 1/8 W1-118-202-25 Capacitor *C223L/C223R0.068mfd10.0 mfd 16 V E510601610 *Minus to emitter of Q218L / Q218R RadioFans.CN 收音机爱 好者资料库 harman/kardon Service Bulletin Service bulletin # 9601 -January 1996Warranty labor ra
11、te: MINOR repair To: All harman/kardon Service Centers Models:AVR-20/AVR-20II Surround receiver/amplifier AVR-25/AVR-25II Subject: Poor or intermittent reception of FM _ In the event you receive a unit from a consumer with a complaint “FM cuts out intermittently” use the procedure listed below in ad
12、dition to the procedure listed in the service manual for FM alignment. To supplement the manual, for FM center tuning alignment follow these procedures; AVR20/AVR20II AlignmentEquipment settings AdjustAdjust For QuadratureTune to a known strong FM station around center of the band (98.1MHz) T8030 VD
13、C across R809, confirm by tuning to another strong station. Repeat step 1 in service manual for minimum distortion. Repeat both steps again for optimum sensitivity. *note: step #4 in AM IF states adjustment point VR802, should be VR801 step #2 in FM IF states adjustment point VR801, should be VR802
14、AVR25/AVR25II AlignmentEquipment settings AdjustAdjust For QuadratureTune to a known strong FM station around center of the band (98.1MHz) T9030 VDC across R914, confirm by tuning to another strong station. Repeat step 1 in service manual for minimum distortion. Repeat both steps again for optimum sensitivity. harman/kardon Incorporated, 80 Crossways Park West, Woodbury, New York 11797 (516) 496 3400 RadioFans.CN 收音机爱 好者资料库