NAD-T752-avr-si2(1) 维修电路原理图.pdf

上传人:cc518 文档编号:152389 上传时间:2022-07-07 格式:PDF 页数:3 大小:213.39KB
下载 相关 举报
NAD-T752-avr-si2(1) 维修电路原理图.pdf_第1页
第1页 / 共3页
NAD-T752-avr-si2(1) 维修电路原理图.pdf_第2页
第2页 / 共3页
NAD-T752-avr-si2(1) 维修电路原理图.pdf_第3页
第3页 / 共3页
亲,该文档总共3页,全部预览完了,如果喜欢就下载吧!
资源描述

《NAD-T752-avr-si2(1) 维修电路原理图.pdf》由会员分享,可在线阅读,更多相关《NAD-T752-avr-si2(1) 维修电路原理图.pdf(3页珍藏版)》请在收音机爱好者资料库上搜索。

1、 Service Information T752Circuit ChangePROBLEM: Muted audio with certain dvd players using the coaxial/opticalinputs .CAUSE: The incoming digital signal isnt recognized as a valid signal.Certain DVD players set the “v” bit incorrectly.SOLUTION: Upgrade software so the receiver will recognise the inc

2、omingsignal. Follow the instructions below for upgrading.Determine software version.1. Turn on the unit and then select an input (eg. DVD) .2. Now press the AUDIO and VIDEO buttons at the same time for 1-2seconds.3. The version of software will appear in the display like, 1.04 A6 or 1.04 A7.4. The A

3、6 or A7 designation determines which microprocessor to use.5. The current software in the microprocessors are 1.06 A6 or 1.06 A7.6. The receiver will not turn on if you try using A6 microprocessors for unitswhich use A7 software.Replacing the microprocessor (see attached photo)1. Remove the top cove

4、r.2. The front panel is easily removed .The top of the front panel is held inplace with four screws on top and five on bottom.3. Once the screws are removed pull the front panel forward and unplugthe ribbon cable on your right side and the four pin connector as well.4. Unplug the three pin and eight

5、 pin cables on the left side.5. The microprocessor can now be removed.6. Locate U201, see diagram for reference.7. Using a PLCC extractor tool remove the microprocessor.(Dont use a screwdriver as this may crack the socket!)8. When inserting the microprocessor line up the dot on the top with thearrow

6、 on the socket.9. Reconnect the cables and secure the front panel.RadioFans.CN 收音机爱 好者资料库RESETTING T752If you experience difficulties with the T752 after this procedure thenreset the unit as described below,North American units “AH”The T752 can be reset by pressing the VIDEO and the TONEDEFEAT butto

7、ns at the same time for 1-2 seconds.ALL Other Countries “C”The T752 can be reset by pressing the VIDEO and the TONECONTROLS buttons at the same time for 1-2 seconds.Photo of U201Contact:NAD Electronics International633 Granite CourtPickering, ON Canada L1K 3K1Voice: 905-831-0799 FAX 905-837-6357 RadioFans.CN 收音机爱 好者资料库

展开阅读全文
相关资源
猜你喜欢
相关搜索
资源标签

当前位置:首页 > 功放/音响/收扩 > NAD

copyright@ 2008-2023 收音机爱好者资料库 版权所有
备案编号:鄂ICP备16009402-5号