Studer-A80-loc-mod 维修电路原理图.pdf

《Studer-A80-loc-mod 维修电路原理图.pdf》由会员分享，可在线阅读，更多相关《Studer-A80-loc-mod 维修电路原理图.pdf（10页珍藏版）》请在收音机爱好者资料库上搜索。

1、RadioFans.CN 收音机爱 好者资料库RadioFans.CN 收音机爱 好者资料库 PROFESSIONAL AUDIO EQUIPMENT Telephone: +41 (0) 44 870 75 11 Althardstrasse 30, CH-8105 Regensdorf, Switzerland Telefax: +41 (0) 44 840 47 37 A80 Autolocator - Y-IHALT.doc Page 1 Professional Audio GmbH A80 Autolocator Alignment instructions for Stabili

2、zer 1.328.044.82: ? Connect nominal load to INTSUP, pin 10 - 14 of J3 (e.g. Autolocator) (ca. 2.5 A / DC). ? Adjust R4 for +6V ( 0.02V) EXTSUP on pin 15 / 16 of plug J3. ? Interrupt mains supply voltage t = 0 ? Monitor the internal supply voltage drop of INTSUP of 5.2V (nominal value) on a storage s

3、cope. ? Adjust the pot. meter R13 that way, that the delay of the signal Y-IHALT changes from the high level into low level in the time window which is given by the values of +5.05V and +4.75V of the supply voltage INTSUP. (see drawing below). The signal Y-IHALT is used to enable the Microprocessor when the supply voltage is fully present and to stop the MPU in case of power failures.(see diagram below). Make sure that the Stabilizer board 1.328.044.xx is modified to Index .82.