《IC-7000_review_Bjarne_Mjelde_2006.pdf》由会员分享，可在线阅读，更多相关《IC-7000_review_Bjarne_Mjelde_2006.pdf（4页珍藏版）》请在收音机爱好者资料库上搜索。
1、Another Icom Gem: The IC-7000 Bjarne Mjelde October 2006 www.kongsfjord.no Finally. It has been on my wish list since it was released, but Ive been holding back. A new receiver (or transceiver in this case) always has its early production run flaws, and there were some issues with the IC-7000 that k
2、ept me from buying it. In August I gave in to my basic instincts (not the Sharon Stone kind of thing) and ordered one after I got a good offer from a Norwegian retailer. It is very small. Well, since I already have an IC-703 I shouldnt be surprised, but fact is: Its even smaller than the IC-703. WHD
3、 is 167x58x180mm and the weight is 2.3 kg. I am a metric man so if you want lbs and inches, you do the math. Of course, power is extra. For transmit it will need 22A at 100 watts; for receive it requires 1.6A at full volume. Specs: AM sensitivity 0.5 - 1.8 MHz is 13 V with preamp on. For the MW DX-e
4、r: Awful. But a friend of mine bought one last winter, and his IC-7000 measured around 1 V so obviously the Icom specs were overly conservative as usual. So I took the chance and ordered one, hoping that my IC-7000 would not be much different. Excellent bandwidth options. All DSP. One can choose any
5、 set of three bandwidths for each mode from a palette ranging up to 10 kHz for AM. A bit like the 746Pro except the latter has fixed AM bandwidths. It tunes from 30 kHz to 199 MHz and 450 to 470 MHz, including the Broadcast FM band and VHF TV channels. Display The display is 2.5. Small, in fact smal
6、ler than that of the IC-703. It is razor sharp though. There is a wealth of information in the display but a logical mix of colours and excellent contrast makes it easy to gain information from. Three different colour schemes are available, of which the default appeared to be best suited for me. I h
7、ad the TV mod done and the TV picture is very sharp, but a 2.5 TV is not very pleasant to look at in the long run. Controls The controls are mostly situated on the sides and bottom (function keys) of the display, all are illuminated. The Mode control carousels between the different available modes b
8、y short presses; AM/FM and USB/LSB are selected with long presses. Any modes that are not needed can be removed by a menu choice, so if you only need AM and SSB you dont have to toggle through RTTY and CW. The bandwidth is selected by toggling the FIL function key below the display. More on that lat
9、er. The IC-7000 has separate controls to select Noise Reduction, Noise Blanker, Auto-Notch and Manual Notch. There are pot-like controls for Audio Gain and RF Gain/Squelch, and for Twin PBT which double as Memory Selector and RIT. For visually impaired users there is a voice synthesizer button for f
10、requency, mode and S-meter reading (selectable). Like other present Icom radios, it has a Tuning Step (TS) button. Very handy. And some HAM related controls and functions I havent paid much attention to. The tuning knob is well made with adjustable friction. It can also be set to detent according to
11、 the selected tuning step. Sensitivity While I set up and warmed up the signal generator I compared it with the very sensitive IC-703 and became quite optimistic. I had reason to. On the upper part of MW, sensitivity was around 0.7 V. On the middle part around 0.9, and the lower part around 1.0 V do
12、wn to 1.3 on 510. LW is a joke. around 25 V on 310. I didnt go deeper. SW sensitivity was close to 0.5 V. Measured with 6 kHz bandwidth AM, 30% modulation and preamp on. These figures are in fact 3-5dB better than my friends IC-7000. Since I was expecting no better than 1 V, I am well content. But w
13、hy does it appear to perform worse with decreased frequency? The answer is rather embarrassing for Icom and it was Dallas Lankford who found it. It has a flaky preamp! He found that if the preamp is disengaged, and a Norton push-pull preamp is placed between the antenna and receiver instead, the IC-
14、7000 will remain its excellent sensitivity at least down to 200 kHz. Indeed it is so. The receiver was very quiet when I tuned the LF band with the preamp on. When I switched it off, the signal level increased dramatically! I noticed this down to about 200 kHz, when the difference tended to decrease
15、. Ingy 153 kHz was about equal level with and without preamp. I didnt bother to put up the signal generator for exact measurements. Maybe I will one day. Todays Word of Wisdom then: If you want to tune LF with the IC-7000, do NOT engage the preamp. Selectivity Each mode has three bandwidth choices b
16、ut these choices can be determined by the user, up to 3.5 kHz for SSB and up to 10 kHz for AM. Each bandwidth can be narrowed in by using the Twin PBT control, similar to the other Icom DSP receivers/transceivers. I have no way of measuring the ultimate selectivity of the bandwidths, but they appear
17、 to be excellent, every bit as good as the IC- 746Pro. Fighting the interference Apart from excellent selectivity, the IC-7000 is loaded with tools for enhancing a signals S/N ratio. The Noise Blanker is as far as I can see a traditional tool that should cope with ignition noise and similar pulse-ty
18、pe noise. It is adjustable. Fights off the occasional Loran C noise well. The Noise Reduction is adjustable as well, and a modest level of NR (2-4 out of 10) actually increases the S/N ratio of the station by a couple of dB. In some cases the difference between readable and not readable. The functio
19、n works more or less the same way as in the 746Pro and is a useful tool. The Auto Notch Function deals effectively with hets, up to three tones at a time, and it tracks the tones when tuning (or if the tones move). The Manual Notch Function can be set to attenuate a frequency. Actually there are two
20、 manual notch filters, each can be tuned to the desired frequency and they can be individually set to Wide, Medium or Narrow filter width. The filter width is pure guesswork since the IC-7000 user manual is rather opaque on the properties of the MNF. But the IC-746Pros manual notch is 70 Hz wide, an
21、d that might fit with Narrow. So maybe Medium is 200 Hz and Wide is 500 Hz? My guess is as good as anyones. By trial and error, I found that the tuning range is +/- 5kHz. I will dwell a little with the MNF because I discovered that it is in fact a wonderful tool. I was listening to a noise-ridden Ra
22、dio America, Paraguay on 1480 (LSB to avoid the DRM hiss from 1485, hence subject to splatter from 1476), when I more or less by chance turned on the MNF function. Splatter almost gone! And I hadnt even tried to tune the MNF filters! Now, what was going on here. I tuned a 746Pro to 1480 and tried to
23、 engage its (single) MNF to reproduce the effect. No way. Apparently, the MNF, especially when set to Wide filter width, is capable of reducing the effects of splatter with a significant amount, resulting in a noticeable (I was about to use the word dramatic but Ill hold my breath) improvement in th
24、e signals readability. I have a couple of recordings which I can email to anyone interested. DRM hiss was also reduced significantly, but I have yet to find out if it means that stations can be dug out of the noise. Effective use of the MNF may require some training, but the function alone makes my
25、IC-7000 the receiver of choice when interference is very tough. The MNF can work together with the Auto Notch Filter as well. Keypad missing Well, not really. A small radio like this cant have a keypad built in. For the IC-703 I bought and built John Hansens Millenium QSYer. Its functions are rather
26、 basic but it works well as a frequency input device. But the IC-7000 has a microphone which doubles as a remote/keyboard. It contains most of the functions one needs, including frequency input, mode change, filter change, up and down tuning and memory functions. The keypad has a rubberised feel and
27、 need a distinct pressure to make contact. It works OK as a remote keypad but the spiral cord is rather thick (as is usual with this kind of equipment). Also, keying a new frequency is somewhat awkward. First, press a button named F- inp/Ent (probably short for Frequency Input/Enter), then the frequ
28、ency including trailing zeros (100s and 10s Hz), then press F-inp/Ent again. So, keying 1470 requires eight key presses while the Millenium QSYer requires only five. The up/down buttons come in very handy though so I will probably use the microphone instead of buying another Millenium QSYer. Audio q
29、uality is generally very good. But the audio from the external speaker jack and headphone jack is somewhat hissy. Seems like the hiss is in the 5-6 kHz area. It is in fact annoying. Much to my surprise though, the line-out does NOT contain hiss. I connected my ELPAF filter to the audio output and th
30、at cured the hiss problem. That done, it is evident that the receiver itself is in fact very quiet, even compared to the 746Pros. I had the pleasure of comparing audio quality of 4KZ-1620 when it was mainly at or below threshold level. The IC-7000 matched, and partly surpassed, the IC- 746Pro. I got
31、 the same impression during the night with massive interference from EU stations. The use of the Auto or Manual notch filters and noise blanker does not degrade the audio quality much, contrary to what I have experienced when using the UT-106 DSP unit with the R-75 or IC- 703. The 8 kHz Tone Early p
32、roduction runs had an 8 kHz tone in the audio circuit which was annoying and of course an embarrassing design flaw. Swedish Radio Supply had removed this prior to shipment. IC-7000s with serial numbers higher than 0202151 (Europe) and 0504451 (USA) do not have this problem i.e. all IC-7000s produced
33、 from early spring 2006 and onwards. If you happen to have an IC-7000 with the 8 kHz tone present, contact your Icom service centre. Icom has a Service Information Bulletin on the issue. Conclusion The Icom IC-7000 is an excellent SW and MW DX receiver. It is compact, has excellent sensitivity and selectivity and has all the necessary tools to pull a station out of the noise mud. It is not cheap though at USD 1500/NOK 14000/GBP 1000, and of course it doesnt hear twice as well as a radio that costs half the price.
免费区 
