Rauland Telecenter V - Tc41058 12-Volt Line Adapter 电路图.pdf

《Rauland Telecenter V - Tc41058 12-Volt Line Adapter 电路图.pdf》由会员分享，可在线阅读，更多相关《Rauland Telecenter V - Tc41058 12-Volt Line Adapter 电路图.pdf（5页珍藏版）》请在收音机爱好者资料库上搜索。

1、Installation KI-1885 TC41058 12-Volt Line Adapter Rauland-Borg Corporation Issued: 06/26/98 Page 1 of 5 RadioFans.CN 收音机爱 好者资料库 KI-1885 TC41058 12-Volt Line AdapterInstallation Copyright 1998 by Rauland-Borg Corporation, all rights reserved. This document contains users information on technology tha

2、t is proprietary to Rauland-Borg Corporation. Permitted transmittal, receipt, or possession of this document does not express license or imply any rights to use, sell, design or manufacture this information. No reproduction, publication, or disclosure of this information, in whole or in part, shall

3、be made without prior written authorization from an officer of Rauland-Borg Corporation. Rauland-Borg Corporation Rauland-Borg Corporation 3450 West Oakton Street Skokie, Illinois 60076-2958 (847) 679-0900 RadioFans.CN 收音机爱 好者资料库 KI-1885 TC41058 12-Volt Line AdapterInstallation Table of Contents GEN

4、ERAL INFORMATION. 4 DESCRIPTION. 4 INSTALLATION. 5 KI-1885 TC41058 12-Volt Line AdapterInstallation Page 4 of 5 (06/26/98) General Information Description This package contains the Rauland TC41058 12V Line Interface Module, which provides 12-volt telephone service in the Telecenter V system. 1 KI-18

5、85 TC41058 12-Volt Line AdapterInstallation Page 5 of 5 (06/26/98) Installation Using an anti-static guard, follow this procedure to install or replace the module: 1. Turn off the power to the Telecenter system. 2. Remove the metal panel where the LLM board is located. 3. Pull the LLM board out of t

6、he system by grabbing the two large holes in front of the printed circuit board. 4. Take the TC41058 out of the box. 5. Remove the faulty line adapter from the LLM board and replace with the new one. Be sure the 10-pin connector is aligned according to the signs on the p.c. board and it is pushed firmly to the end. 6. Re-install the LLM board into the slot in the system. 7. Re-install the metal panel. 8. Turn the power back on: the system should be working as normal. 2