Aiwa-XRMS3-cs-tiga0016e0 电路图 维修手册.pdf

《Aiwa-XRMS3-cs-tiga0016e0 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Aiwa-XRMS3-cs-tiga0016e0 电路图 维修手册.pdf（1页珍藏版）》请在收音机爱好者资料库上搜索。

1、1/1 Service Technical Information MODEL NO. XR MDS7 / MS3 SUBJECT Noise During CD PlaybackREF.No.:GA0016E0 DATE:12. MAY. 2000 There are times when complaint is made thatNoise comes from the speaker during CD playback. This is particularly noticeable at low volumes. Please take the following counterm

2、easures against the above problem. Method of verifying the symptom: Playback the MUTE track of the CD test disk TCD 782 Tr. 22, and verify the noise from the speaker. 1) Cut the pattern (at two locations) between Pin 2 of IC201 and the + terminal of C205. 2) Cut the pattern (at two locations) betwee

3、n Pin 4 of IC201 and the + terminal pin of C206. 3) Connect Pin 2 of IC201 and the + terminal pin of C205 using a jumper wire. 4) Connect Pin 4 of IC201 and the + terminal pin of C206 using a jumper wire. 5) Fix the connected jumper wires using a spot of glue (1600Y). Since it is possible that the s

4、ymptom may not get improved depending on the position of the wires, Adjust the position of the wires and fix them at the best position. There is no special specification for the wires. GRCode No.Access CodeModified Ser. No.Parts Schedule 1 24 IC201 R221 R219 C206 C205 IC101 IC201 MAIN C.B 3.WIRE 1.Pattern cut 2.Pattern cut 5.GLUE 5.GLUE 4.WIRE RadioFans.CN 收音机爱 好者资料库