Philips-DVP-6620-Service-Manual(1) 电路图 维修手册.pdf

《Philips-DVP-6620-Service-Manual(1) 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Philips-DVP-6620-Service-Manual(1) 电路图 维修手册.pdf（5页珍藏版）》请在收音机爱好者资料库上搜索。

1、Instruction.1-1 Software Upgrade.2-1 Accessory list.3-1 Revision List.4-1 This simple Service Manual is for Exchange Scenario TABLE OF CONTENTS Page 3139 785 34700 Version 1.0 DVP6620 Service Manual PHILIPS GB Copyright 2008 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights res

2、erved. No part of this publication may be reproduced, stored in aretrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. CLASS 1 LASER PRODUCT Published by KC- 0803 Service Audio Printed in The Netherla

3、nds Subject to modification DVP6620/12 Service DVD Player RadioFans.CN 收音机爱 好者资料库 How to remove the CD manually from the tray 1. Please do as below instruction in case the tray can not be open: I. Power off the DVD player. II. Please gently move the CD door follow the below arrowhead (Figure1). 1-1

4、Figure 1 RadioFans.CN 收音机爱 好者资料库 Software upgrade Preparation to upgrade software 1) Start the CD Burning software and create a new CD project (Data Disc) with the following setting: Label: DVPXXXX (No need the label name) File Name: DVPXXXX_XX.BIN Power on the set and open the tray, then press to c

5、heck the File Name. Note: It is required capital letter for the File System name 2) Burn the data onto a blank CDR A. Procedure for software upgrade: 1) Power on the set and insert the prepared Upgrade CDR. 2) The set will starts reading disc & response with the following display TV screen: Upgrade

6、File DETECTED Upgrade? Press Play TO START. 3) Press button to confirm, then screen will display : Files coping UPGRADING 4) The upgraded disc will automatically out when files coping complete, then take out the disc. 5) About 1 minute later, the trace will automatically close when upgrading complet

7、e. B. Read out the software versions to confirm upgrading 1) Power on the set and press button on the remote control. 2) Pressbutton to check the software information. The software version and other information are display on the TV screen as follows: Version XX.XX.XX.XX (Main version) SUB-VER XX.XX

8、.XX.XX (software version of application software) 8032 XX.XX.XX.XX Servo XX.XX.XX.XX (software version of Servo) RISC XX.XX.XX.XX DSP XX.XX.XX.XX Region Code X 2-1 Caution: The set must not be power off during upgrading, Otherwise the Main board will be damaged entirely. RadioFans.CN 收音机爱 好者资料库 Item No. 12NC No. Description RC 996510007598 Remote control AVCable 996510008503 AUDIO CABLE YUV 996510007599 3RCA/M TO 3RCA/M L=1.5M (YUV Cable) Accessories Spare Parts List 3-1 4-1 Revision List Version 1.0 Initial Release