Grundig-Sonoclock-53-SC-5303-Service-Manual电路图 维修手册.pdf

《Grundig-Sonoclock-53-SC-5303-Service-Manual电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Grundig-Sonoclock-53-SC-5303-Service-Manual电路图 维修手册.pdf（10页珍藏版）》请在收音机爱好者资料库上搜索。

1、Sonoclock 53 SC 5303 DCF Service Document Exchange Set Es gelten die Vorschriften und Sicherheitshinweise gem dem Service Manual Sicherheit, Material- nummer 720108000000, sowie zustzlich die even- tuell abweichenden, landesspezifischen Vorschrif- ten! The regulations and safety instructions shall b

2、e valid as provided by the Safety Service Manual, part number 720108000000, as well as the respective national deviations. S Dieses Service Dokument ist nur in Datenform verfgbar This Service Document is only available as data nderungen vorbehalten/Subject to alteration Made by GRUNDIG in Germany H-

3、S 43 1003 S Service Manual Sicherheit Safety Materialnr./Part No. 720108000000 ? RadioFans.CN 收音机爱 好者资料库 Sonoclock 53 SC 5303 DCF? RadioFans.CN 收音机爱 好者资料库 Sonoclock 53 SC 5303 DCF? RadioFans.CN 收音机爱 好者资料库 Sonoclock 53 SC 5303 DCF? Sonoclock 53 SC 5303 DCF? Sonoclock 53 SC 5303 DCF? Sonoclock 53 SC 5

4、303 DCF? Sonoclock 53 SC 5303 DCF? Sonoclock 53 SC 5303 DCF? Step Signal source ( AM RF Gen. ) Connect toSet signal to Aligment indicator connect to Socilloscope or SSVM Set radio dial toAdjustAdjust forRemarks 1A standard radiation loop460 KHzTP2 Detector Output TerminalQuiet pointT2Maximum 2 Signa

5、l source ( AM RF Gen. ) Connect toSet signal to Aligment indicator connect to Socilloscope or SSVM Set radio dial toAdjustAdjust forRemarks 1 515 KHz ( modulated ) 515 KHz ( lowest end ) T1 ( Ssc, coil ) 2 1640 KHz ( modulated ) 1640 KHz ( Highest end ) C3 ( Osc, coil ) 3 600 KHz ( modulated ) 600 K

6、Hz C5 ( Ssc, coil ) 4 1440 KHz ( modulated ) 1440 KHz C4 ( Ssc, coil ) 5 Step Signal source ( FM RF Gen. ) Connect toSet signal to Aligment indicator ( ocsilloscope, VTVM Connect to ) Set radio dial toAdjustAdjust forRemarks 1 87.35 MHz modulated 87.35 MHz ( lowest end ) C2 ( Osc, coil ) 2 108.25 MH

7、z modulated 108.25 MHz ( Highest end ) C1 ( Ssc, trimmer ) 390 MHz modulated 900 MHz c1 ( RF coil ) stretrch or squeeze 4 106 MHz modulated 106 MHzC2 ( RF trim ) 5 AM IF ALIGNMENT * UK models must not be able to tune below 87.5 MHz Repeat Steps 3 and 4 as necessary to minimize tracking error. Also r

8、epeat steps 1 and 2 if necessary. MW RF ALIGNMENT Volume control max- position FM FR ALIGNMENT Volume control max- position Reqpeat for maximum output TP 1,GND (Test point ) through matching network if necessary Across speaker voice coilMaximum A standard radiation loop antennaAcross speaker voice coilMaximum Repeat Steps 3 and 4 as necessary to minimize tracking error. Also repeat steps 1 and 2 if necessary. Sonoclock 53 SC 5303 DCF?