《Marantz-CDR510-cd-mz03032 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Marantz-CDR510-cd-mz03032 电路图 维修手册.pdf(1页珍藏版)》请在收音机爱好者资料库上搜索。
1、 100 Corporate Drive Mahwah, NJ 07430 Service Bulletin No. : MZ03-032 Date: December 8, 2006 _ Model: CDR510 Subject: Wrong indication on the display. Symptom: The problem occurs in the following operation. A. The display shows “NOT FINALIZE” 1. First, Insert the unfinalized Disc in the tray of CD-R
2、ecorder, then close the tray. 2. Press the OPEN/CLOSE button, Remove the unfinalized Disc from the tray. 3. Insert a CD-DA Disc to CD-Recorder, the tray is pushed by hand and closed. 4. Press the OPEN/CLOSE button. 5. The display shows “NOT FINALIZE”. After the software change, the display shows “OP
3、EN” B. The display incorrectly shows “END WRANING”. After the software change, the display shows “WARNING” Solution: Replace the MICRO PROCESSOR (Flash Rom) QU01 on the PS16- SERVO/MP3/CPU CIRCUIT BOARD. Version # can be confirmed in SERVICE MODE. Refer to the CDR510 service manual page14 for detail
4、s. Displayed “VER_0-24 P00“. Parts: FORMER NEW Ref # Description Part Number Description Part Number QU01 MPU (FLASH ROM) *HS12AKF0R MPU (FLASH ROM) *HS12AKF2R Serial Number Range: The countermeasure applies to this type of claim only. _ CONFIDENTIALITY NOTICE: The information contained in this docu
5、ment is intended for the exclusive use by MARANTZ Authorized Service Centers and their employees. This document may contain information that is privileged, confidential and may be protected from disclosure under applicable laws and terms of the MARANTZ Service Agreement. Any distribution, disclosure, dissemination or copying of this document and the information it contains is prohibited. No responsibility is will be accepted by MARANTZ for any damage, injury or loss resulting from the misuse of the information contained in this document. RadioFans.CN 收音机爱 好者资料库