Panasonic-CR16-cdm-sm 电路图 维修手册.pdf

《Panasonic-CR16-cdm-sm 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Panasonic-CR16-cdm-sm 电路图 维修手册.pdf（19页珍藏版）》请在收音机爱好者资料库上搜索。

1、1.1. Procedure for removing CD loading mechanism 1. Turn off by pressing power SW in the body. 2. Pull out AC plug after the indication of GOOD-BYE, then disassemble the body. 3. Disassemblethebody,andtakeoutCDloading mechanism. 4. Perform disassembly according to the following procedure for disasse

2、mbly. 1.2. CR16 mechanism disassembly procedure 1.2.1. Gera for servicing (as jig) information This unit has a gear which used for chacking items (open/close of disc tray, up/down operation of traverse unit by manually) when servicing. (For gear information, that is described on the items for disass

3、embly procedures.) Forpreparationofgear(forservicing),performthe procedures as follows. In case of re-servicing the same set, the “ gear for servicing” may be took off because it had been used. So, the “gear for servicing” must be stored. 1. Remove the gear attachied to top cover of CD loading mecha

4、nism. 2. Insert the hexgonel wrench (2.5mm) into the gear. 1.2.2. Replacement for the disc tray 1 CR16 MECHANISM DISASSMBLY/ASSEMBLY PROCEDURE 1 RadioFans.CN 收音机爱 好者资料库 2 RadioFans.CN 收音机爱 好者资料库 1.2.3. Replacement for the traverse deck Follow the (Step 1) - (Step 10) of item 1.2.2. 3 RadioFans.CN 收音

5、机爱 好者资料库 1.2.4. Disassembly for CD loading unit Follow the (Step 1) - (Step 10) of item 1.2.2. Follow the (Step 1) - (Step 4) of item 1.2.3. 4 5 6 1.3. CR16 MECHANISM ASSEMBLY PROCEDURE The following specified greases and/or oil must be applied when some specific parts are changed. 1. Floil grease (VFK1298) : The floil grease must be applied to tray, tray (L) and tray (R). 2. Hanarl oil (VFK1700) : The hanarl oil must be applied to any parts with grease other than the said parts. 7 8 9 10 11 12 13 14 15 16 17 18 19