Crosley-Corp-56TN 电路原理图.pdf

《Crosley-Corp-56TN 电路原理图.pdf》由会员分享，可在线阅读，更多相关《Crosley-Corp-56TN 电路原理图.pdf（5页珍藏版）》请在收音机爱好者资料库上搜索。

1、MANUAL OF 1948 MOST-OFTEN-NEEDED RADIO DIAGRAMS CROSLEY ALIGNMENT PROCEDUREMODEL 56TN 1. Turn the tuning condenser to the completely closed position against the stop and set the dial pointer to the reference line at the end of the dial scale. 2. Connect the output meter across the speaker voice coil

2、. 3. The r.f. signal input from the signal generator should be connected to the external antenna lead. Connect the signal generator ground through a 0.1 mfd. condenser to B (pin 3 on 12SK7 tube socket). 4. Turn the volume control on full and adjust the signal generator output to produce approximatel

3、y mid-scale deflection of the output meter, but maintain signal generator output as low as possible to prevent AVC action in the receiver. NOTE: When aligning the short-wave oscillator trimmer (C), be sure that the circuit is aligned at the correct frequency and not at the image frequency which is 9

4、10 kilocycles lower as indicated by the receiver dial. To check: Tune in the generator frequency, then increase the generator output and tune in the image frequency. The image frequency should be weaker than the fundamental and aud ible 910 kilocycles lower on the receiver dial. If the image cannot

5、be tuned in, the oscillator trimmer is adjusted to the wrong peak; i.e., the oscillator trimmer may be adjusted to the image or one qf the harmonics instead of the fundamental frequency. The correct peak is the second one heard as the trimmer adjustment screw is opened from the completely closed position. 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 RadioFans.CN