DeWald-Radio-Mfg-Corp-E-520 电路原理图.pdf

《DeWald-Radio-Mfg-Corp-E-520 电路原理图.pdf》由会员分享，可在线阅读，更多相关《DeWald-Radio-Mfg-Corp-E-520 电路原理图.pdf（4页珍藏版）》请在收音机爱好者资料库上搜索。

1、LOOPTENNA MANUAL OF OFTEN-NEEDED RADIO DIAGRAMS DeWALD RADIO INSTRUCTION SHEET MODEL E-520 Alignment instructions for this model given on page 26, over. 2 O o o CO . r r*. j o u u u Z 2 o 00 O 03 rI 3 u o m co d w o H -P bO O 03 d p d -P W c H d o d G tiO tiO H T* H Q s o o o55 m 00 0Q SI U 00 to to

2、 BOTTOM VIEW 收音机爱 好者资料库 RadioFans.CN MANUAL OF 1951 MOST-OFTEN-NEEDED RADIO DIAGRAMS Alignment Instructions for DeWald Radio Model E-520 (Circuit Diagram on page 25) To calibrate Model E-520 receiver, connect the output of a signal generator in series with a 200 mmfd. fixed condenser to the flexible

3、 antenna lead attached to the loop. Connect the low side of the generator through a 0.1 mfd. condenser to the receiver chassis. The wave band switch should be in the broad cast position. Adjust the generator to 455 KC. and adjust both I.P. transformers (both top and bottom) for maximum signal out pu

4、t. Open the variable condenser for minimum capacity. Turn the wave band switch to short wave ,fl position. Set generator at 24.2 MC. Peak the short wave $1 oscillator trimmer screw (C5) for maximum signal. Next set the generator at 25 MC. and tune in this signal on receiver. Adjust short wave #1 R.F

5、. trimmer screw (C2) for maximum signal. The low frequency end of the dial is automatically adjusted by a fixed padder conden ser. Next turn band switch to short wave #2 position. Rotate drive shaft until variable condenser of the receiver is open all the way. Adjust generator to 8 MC. Adjust the sh

6、ort wave #2 oscillator trimmer screw (C4) until maximum signal is secured. Next set generator at 7 MC. Tune in this signal on receiver, and adjust short wave #2 R.F. trimmer screw (Cl) for maximum signal strength. The low frequency end of the dial is automa tically adjusted by a fixed padder condens

7、er. Next turn band switch to broadcast position. Adjust generator to produce 1500 KC. and tune in this signal on receiver. Adjust the broadcast oscillator trimmer screw (C3) for maximum signal. To adjust the low end of the dial, set the generator and receiver at 600 KC. Peak the broadcast padder (C7) for maximum output. The variable condenser should be rocked slightly during this ope ration. Keep the signal generator output as low as possible - when making all these adjustments. PHONOGRAPH MOTOR 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 RadioFans.CN