General-Electric-Co-T140A 电路原理图.pdf

上传人:cc518 文档编号:306981 上传时间:2026-02-27 格式:PDF 页数:1 大小:2.10MB
下载 相关 举报
General-Electric-Co-T140A 电路原理图.pdf_第1页
第1页 / 共1页
亲,该文档总共1页,全部预览完了,如果喜欢就下载吧!
资源描述

《General-Electric-Co-T140A 电路原理图.pdf》由会员分享,可在线阅读,更多相关《General-Electric-Co-T140A 电路原理图.pdf(1页珍藏版)》请在收音机爱好者资料库上搜索。

1、tBUPLATE TWO SPURS 3 2a AT OOjv OA SET VOLUME CONTROL AT MAXIMUM COMCCT OUTPUT MITER OR SCORE ACROSS VOICE COIL MOUCTIVELT COUPLE SIGNAL CEMERATO* to RECEIVER STIR St SET SIG CEN AT A9SMC WITH RECEIVER TIMMS CANO OR N STER S SET SIG SEN AT HJOIC. WITH RECEIVER TIMMS GANG OREM. STIRS-SET SIG GEN AT 1

2、900KC TUNE RECEIVER TO I900RC V5 33W4 VOLUME R-20, MOST-OFTEN-NEEDED 1960 RADIO SERVICING INFORMATION GENERAL ELECTRIC MODELS T-140A, T-141A TO REMOVE CABINET BACK Place cabinet on end using a soft cloth to protect the finish. insert a screw driver between cabinet bottom and cabinet back next to one

3、 of the slots in the cabinet bottom. Turn screw driver, forcing tab on bottom of cabinet back out of its slot. Repeat procedure with other tab on cabinet back. Slide out and down, releasing top tabs from top slots. TO REMOVE CHASSIS After removing cabinet back, remove fishpaper chassis support. Then

4、 remove the screw on cabinet bottom holding metal chassis support. Pull off loud ness control knob and loosen hex nut on loudness con- TO VOLUME CONTROL TO SWITCH trol shaft. The tuning knob is a captive knob and remains in the cabinet front. Unsolder speaker leads. Close the tuning gang to prevent

5、any possible damage to the plates. Slide one hand under the printed chassis board placing the fingers over the front edge. Slide the board back out of the grooves on both ends, simultaneously removing the tuning gang shaft from the tuning knob. When replacing the chassis, close the tuning gang and l

6、ine the flat side of the gang shaft up with the flat side of the tuning knob opening. Place the ends of the board in the grooves and push on the edge of the board, not on the components. The tuning shaft will enter the tuning knob and the front edge of the board will seat itself in the grooved bosses inside the cabinet front. Replace the board supports. TO ANTENNA LI TO INTERLOCK TO VOLUME I I CONTROL 44 收音机爱 好者资料库 RadioFans.CN

展开阅读全文
相关资源
猜你喜欢
相关搜索
资源标签

当前位置:首页 > 欧美收音机 > General Electric Co

copyright@ 2008-2025 收音机爱好者资料库 版权所有
备案编号:鄂ICP备16009402-5号