Philco-Radio-and-Television-Corp-M-1537 电路原理图.pdf

《Philco-Radio-and-Television-Corp-M-1537 电路原理图.pdf》由会员分享，可在线阅读，更多相关《Philco-Radio-and-Television-Corp-M-1537 电路原理图.pdf（1页珍藏版）》请在收音机爱好者资料库上搜索。

1、VOLUME R-24, MOST-OFTEN-NEEDED 1964 RADIO SERVICING INFORMATION PHILCO Model M-1537 and Model M-1416 (Below) VIA V2 RECORD AMPLIFIER REMOVAL - MODEL M-1537 I l Schematic Diagram, Model M-I4I6 I 1. Remove two Phillips screws from back of cabinet. Dd not remove two screws that fas ten grille to cabine

2、t back. 2. Remove plug on right side of changer base. Grasp washer on changer, hold down screw with long nose pliers. Grasp washer on side opposite washer opening through hole in right side of changer bin. 3. Lift right side of changer and slide changer to the right in order to free left side. 4. Un

3、plug phono power and phono input cables. Set changer aside. 5. With a short screw driver, remove the two Phillips screws holding the amplifier com partment in the cabinet. These screws are located at the top of the changer compart ment and run through the changer bin stop blocks. 6. Loosen phono pow

4、er and phono input cable hold downs. 7. Slide amplifier compartment out of cabinet guiding all cables through openings in side and back of cabinet. 8. Remove knobs and T-nuts located on controls behind knobs. 9. Remove two speed nuts from studs on ampli fier rear flange. Lift amplifier to clear studs and pull away from compartment. 123 收音机爱 好者资料库 RadioFans.CN