Bogen-MSM-Operation-Manual 电路图 维修手册.pdf

《Bogen-MSM-Operation-Manual 电路图 维修手册.pdf》由会员分享，可在线阅读，更多相关《Bogen-MSM-Operation-Manual 电路图 维修手册.pdf（2页珍藏版）》请在收音机爱好者资料库上搜索。

1、MSM Microphone Shock Mount Contemporary design and excellent engineering for desktop and counter use Easy setup and quick plug-in design Superior mechanical noise and vibration handling Ideal fixture for boardrooms, conference rooms, pulpits, podiums, or newsrooms 50 Spring Street, Ramsey, NJ 07446,

2、 U.S.A. Tel: 201-934-8500; Fax: 201-934-9832, 54-2065-01B Specifications subject to change without notice. The MSM is a plug-in shock mount microphone base for desktop and count- er use.Its contemporary design is a complementing fixture for boardrooms, conference rooms, pulpits, podiums, or newsroom

3、s. It is ideal for use with gooseneck microphones and other quick-mount types using XLR (male) type connectors.The black-finish housing is made of lightweight ABS material. It supports the XLR (female) type connector and the thick shock-absorbing rubber cushion. The MSM is easily screwed onto a flat

4、 surface with a maximum thickness of 3/4 providing maximum stability and excellent noise insulation,and vibration handling for live miking situations. The MSM allows convenient wiring with its flush-mounted XLR (female) con- nector.The signal appears across pin nos. 2 and 3 while the ground connec-

5、tion is in pin no. 1. Description Features 5. Drilling Template Printed in USA. 0511 2005 Bogen Communications, Inc. RadioFans.CN 收音机爱 好者资料库 1. Surface Preparation: a. Make sure that the surface on which the MSM will be installed is flat and stable. b. Using the dimensions shown below, drill the hol

6、es for the mounting screws. The thickness of the table/platform must not exceed 3/4. Counter bore hole on bottom of table for thicker tops. 2. XLR (Female) Connector Diagram: Solder 2-conductor with shield microphone cable to connector. Figure shows typical connections for balanced microphones. Chec

7、k instructions for microphone actually being used to confirm proper connections. Installation 3. Mounting: a. Remove the nuts and the washers from the shock mount base. b. Mount the base on the intended surface. c.Tighten the screws enough to ensure stability.Over tightening will suppress shock abso

8、rbing capability of the rubber cushion. 4. Connecting/Removing a Microphone (shown with GDU150): Connecting - The outside diameter of the microphone connectors housing should not exceed 3/4, with its length 3/4 or longer.This is to ensure its com- plete and lock-tight connection with the flush-mounted XLR (female) connector of the shock mount base. Removing - Pull out the microphone while pressing the release tab of the XLR (female) connector of the shock mount base. SIGNAL +? CONDUCTOR SIGNAL - CONDUCTOR 12 3 SHIELD Outside Dimensions RadioFans.CN 收音机爱 好者资料库