《Tascam_ss-cdr1_manual 电路图 维修手册.pdf》由会员分享,可在线阅读,更多相关《Tascam_ss-cdr1_manual 电路图 维修手册.pdf(88页珍藏版)》请在收音机爱好者资料库上搜索。
1、D01017520A SS-CDR1 Solid State/CD Stereo Audio Recorder OWNERS MANUAL RadioFans.CN 收音机爱 好者资料库 IMPORTANT SAFETY PRECAUTIONS 2 TASCAM SS-CDR1 The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructio
2、ns in the literature accompanying the appliance. The lightning flash with arrowhead symbol, within equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the products enclosure that may be of sufficient magnitude to constitute a risk of electric
3、 shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. This appliance has a serial n
4、umber located on the rear panel. Please record the model number and serial number and retain them for your records. Model number Serial number For the customers in Europe WARNING This is a Class A product. In a domestic environment, this product may cause radio interference in which case the user ma
5、y be required to take adequate measures. Pour les utilisateurs en Europe AVERTISSEMENT Il sagit dun produit de Classe A. Dans un environnement domestique, cet appareil peut provoquer des interfrences radio, dans ce cas lutilisateur peut tre amen prendre des mesures appropries. Fr Kunden in Europa Wa
6、rnung Dies ist eine Einrichtung, welche die Funk-Entstrung nach Klasse A besitzt. Diese Einrichtung kann im Wohnbereich Funkstrungen versursachen; in diesem Fall kann vom Betrieber verlang werden, angemessene Manahmen durchzufhren und dafr aufzukommen. TO THE USER This equipment has been tested and
7、found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radi
8、o frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interf
9、erence at his own expense. CAUTION Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the users authority to operate this equipment. For U.S.A. CE Marking Information a) Applicable electromagnetic environment: E4 b) Peak inrush current: 17
10、 A In North America use only on 120V supply. RadioFans.CN 收音机爱 好者资料库 IMPORTANT SAFETY INSTRUCTIONS TASCAM SS-CDR1 3 1 Read these instructions. 2 Keep these instructions. 3 Heed all warnings. 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with dry cloth. 7 Do not bloc
11、k any ventilation openings. Install in accordance with the manufacturers instructions. 8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9 Do not defeat the safety purpose of the polarized or grounding-type
12、plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obs
13、olete outlet. 10 Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11 Only use attachments/accessories specified by the manufacturer. 12 Use only with the cart, stand, tripod, bracket, or table spe
14、cified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13 Unplug this apparatus during lightning storms or when unused for long periods of time. 14 Refer all servicing to qualified service per
15、sonnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Do not ex
16、pose this apparatus to drips or splashes. Do not place any objects filled with liquids, such as vases, on the apparatus. Do not install this apparatus in a confined space such as a book case or similar unit. The apparatus should be located close enough to the AC outlet so that you can easily grasp t
17、he power cord plug at any time. An apparatus with Class I construction shall be connected to an AC outlet with a protective grounding connection. Batteries (battery pack or batteries installed) should not be exposed to excessive heat such as sunshine, fire or the like. Excessive sound pressure from
18、earphones and head- phones can cause hearing loss. The apparatus draws nominal non-operating power from the AC outlet with its STANDBY/ON in the Standby position. RadioFans.CN 收音机爱 好者资料库 IMPORTANT SAFETY PRECAUTIONS 4 TASCAM SS-CDR1 Rack-mounting the Unit Use the supplied rack-mounting kit to mount
19、the unit in a standard 19-inch rack, as shown below. Remove the feet of the unit before mounting. NOTE Leave 1U of space above the unit for ventilation. Allow at least 10 cm (4 in) at the rear of the unit for ventilation. This product has been designed and manufactured according to FDA regulations t
20、itle 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968, and is classified as a class 1 laser product. There is no hazardous invis- ible laser radiation during operation because invis- ible laser radiation emitted inside of this product is completely c
21、onfined in the protective housings. The label required in this regulation is shown at 1. Optical pickup Type : HOP-6201TC Manufacturer : Hitachi Media Electronics Co,Ltd. Laser output : Less than 75 mW on the objective lens (record) Wavelength : 777 to 787 nm CAUTION DONOTREMOVETHEPROTECTIVEHOUSING
22、USING A SCREWDRIVER. USEOFCONTROLSORADJUSTMENTSOR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. IFTHISPRODUCTDEVELOPSTROUBLE, CONTACT YOUR NEAREST QUALIFIED SERVICE PERSONNEL, AND DO NOT USE THE PRODUCT IN ITS DAMAGED STATE. CLASS1MINVISIBLEL
23、ASERRADIATIONWHEN OPEN AND INTERLOCKS DEFEATED. DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS. Safety Information 1For USA 1 Introduction TASCAM SS-CDR1 5 Contents 1 Introduction . 7 Features of the SS-CDR1 .7 Supplied accessories .7 Media considerations .7 About CD-R and CD-RW discs .8 About finali
24、zing .8 Recordable discs .8 Handling of compact discs .8 Never use a stabilizer or printable discs .9 Environmental considerations .8 Beware of condensation .9 About this manual .9 Connections .10 Control connections .10 2 Controls and connectors . 11 Front panel .11 Rear panel .13 Remote control un
25、it (RC-SS1) .13 The home screen .15 Various indicators .16 3 Menu screens . 17 Menu structure .17 Operations in the menu screens .18 4 Preparations . 19 Connections .19 Turning the power on .20 Setting the date and time .20 Adjusting the display .21 Adjusting the contrast .21 Adjusting the brightnes
26、s .21 Inserting a CompactFlash card .22 About the door lock .22 Removing the card .22 Inserting a CD .23 Removing a CD .23 Selecting the device .23 5 Playback . 24 Files that can be played .24 Tracks and files .24 Play area .24 Selecting the type of play area .24 Selecting the current folder or curr
27、ent playlist .25 Basic playback operations .25 Playback .25 Selecting a track .25 Skipping to the previous or next track.25 Specifying a track number.26 Fast-forward/rewind search .26 Time search .26 Time searching from an incomplete entry .27 Time skip .27 Playback modes .27 Specifying the playback
28、 mode .27 Program playback .28 Switching the playback time display mode .28 Power-on play .29 Repeat playback .29 Conventional repeat playback .29 A-B Repeat playback .29 Pitch Control playback .30 Specifying the Pitch Step .30 Key Control playback .31 Using the remotes dedicated key to turn Key Con
29、trol on/off .31 Auto Cue function .32 Using the remotes dedicated key to turn Auto Cue on/off .32 Auto Ready function .33 Turning the Auto Ready function on/off from the front panel .33 Call function .33 Incremental Playback .34 Using the remotes dedicated key .34 Using the menu to make settings .34
30、 Playing back in monaural .35 Resume Playback .35 Flash Start function .36 End of disc/track message (EOM) .37 Specifying an EOM tally output trigger .37 Example of actual use .37 6 Recording . 38 Selecting the input source .38 Using the dedicated remote key to select the source .38 Using the menu t
31、o select the source .38 Input source indicator .39 Specifying the recording file format .39 Using the sampling rate converter .40 Monitoring the input signal .40 Adjusting the input signal level and balance .41 Basic recording operation .41 Finalizing a CD .43 Finalizing operation .43 Switching the
32、recording time display mode . 44 6 TASCAM SS-CDR1 Contents Sync recording . 44 Making settings . 44 Sync Record operation .46 Auto Track function .47 Using the menu .47 Using the remotes dedicated key to switch modes .48 Assigning a new track number manually.48 Applying the compressor while recordin
33、g .48 Specifying the name of the recording file (WAV and MP3 only) .49 7 Using the folder finder . 50 Overview .50 Opening the folder finder screen .50 Navigating in the folder finder screen .50 Operations when a folder is highlighted .50 Operations when a file is highlighted .51 Operations in the f
34、older menu screen .52 Renaming a folder (CF card only) .52 Deleting a folder (CF card only) .52 Undeleting a deleted folder (UNDO) (CF card only) .53 Making a folder the current folder .53 Creating a new folder .53 Adding an entire folder to a playlist (CF card only) .54 Undoing a folder menu operat
35、ion (UNDO) .54 Operations in the file menu screen (CF card only) .54 Editing the file name.55 Deleting a file .55 Adding files to a playlist .56 Dividing a file (DIVIDE) .56 Combining files (COMBINE) .57 Undoing a file menu operation (UNDO) .58 Moving or copying a file (CF card only) .58 Moving a file within a folder .58 Moving or copying a file between folders .59 8