Philips-DVDR-3305-3365-Service-Manual电路原理图.pdf

《Philips-DVDR-3305-3365-Service-Manual电路原理图.pdf》由会员分享，可在线阅读，更多相关《Philips-DVDR-3305-3365-Service-Manual电路原理图.pdf（73页珍藏版）》请在收音机爱好者资料库上搜索。

1、Published by KC-TE 0530 AV Systems Printed in the Netherlands Subject to modifi cation EN 3139 785 30931DVD-Video RecorderCLASS 1LASER PRODUCTContents Page1 Technical Specifi cations and ConnectionFacilities 22 Safety Information, General Notes .To resume recording,press REC 0.To stop the recording,

2、 pressSTOP 9. Wait until the messagedisappears from the display panelbefore you remove the disc.SUPER VIDEORecord ModePicture QualityMaximum Recording Time per Disc1 Hour Mode2 Hour Mode4 Hour Mode6 Hour ModeHigh quality DVD quality-Standard PlayVHS quality-Extended PlayVHS quality-Super Long Play1

3、hour2 hours4 hours6 hours3. Directions For UseEN 93139 785 3093x 4.Mechanical Instructions4. Mechanical Instructions4.1 Dismantling and Assembly of the SetFor item numbers please see the exploded view in Chapter 9.4.1.1 Dismantling of the DVD Loader Tray Cover 1) Inserting a minus screw driver and p

4、ush the lever in the direction as shown in Figure 4-1 to unlock the tray before sliding it out.Figure 4-12) Remove the Tray Cover as shown in Figure 4-2.Figure 4-24.1.2 Dismantling of the Front Panel Assembly1) Remove the 3 screws 188 and release the 2 snap hooks on the side before removing the fron

5、t assembly.1Figure 4-32) Remove the 5 screws 186 to remove the front plate 184 as shown in Figure 4-4.22Figure 4-4EN 10 3139 785 3093x4. Mechanical Instructions4.1.3 Dismantling of the Basic Engine 1) Remove the Cover Tray (See 4.1.1).2) Remove the 4 screws 260 to free the Basic Engine.33Figure 4-53

6、) Place the Basic Engine in the service position by fl ipping the basic engine to the vertical positionFigure 4-64.1.4 Dismantling of the Digital Board1) Remove the 4 screws 272 to loose the Digital Board as shown in Figure 4-7. 44Figure 4-72) Service Position can be achieved by fl ipping the Digital board to the Vertical Position as shown in Figure 4-8.Figure 4-8Note: The cable (just to transfer the service connection to the analog board) from socket 1101 can be removed and use for hyperterminal connection.