Philips-DVDR-3360-H-Service-Manual电路原理图.pdf

《Philips-DVDR-3360-H-Service-Manual电路原理图.pdf》由会员分享，可在线阅读，更多相关《Philips-DVDR-3360-H-Service-Manual电路原理图.pdf（14页珍藏版）》请在收音机爱好者资料库上搜索。

1、Published by KC-TE 0617 AV Systems Printed in the Netherlands Subject to modication EN 3139 785 32060DVDR3360HHDD & DVD RecorderService InstructionCLASS 1LASER PRODUCTContents Page1 Technical Specications and Connection Facilities 22 Test Disc & Repair Hints 53 Firmware Upgrading 64 Service Flow cha

2、rt 75 Directions For Use 12Copyright 2006 Philips Consumer Electronics B.V. Eindhoven, The Netherlands.All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise with

3、out the prior permission of Philips.Version 1.0DVDR3360H/05/31/51/58The 2006 range DVD Recorder products are repaired centrally.Defective sets must be identied, labelled and stored for pick-up.This document gives full instructions for a functional check.Technical information to repair faulty sets is

4、 therefore not provided in this document.To test in-coming sets the following must be performed:1. Verify / Reproduce the customers problem2. Verify that set has latest Firmware (see chapter 3) and upgrade if it is not the latest version.3. Full functional checkEN 2 3139 785 320601. Technical Specic

5、ations and Connection Facilities1. Technical Specications and Connection Facilities1.1 General:Mains voltage : 220V 240V Mains frequency : 50 HzPower consumption (record) : 27 WStandby Power Consumption : 4.5V / 9.5V / 1V / 10kVideo - CinchInput voltage : 1Vpp 3dB Input impedance : 75Video - YC (Hos

6、iden)According to IEC 933-5Superimposed DC-level on pin 4 (load 100k)3.5V is detected as 16:9 aspect ratioInput voltage Y : 1Vpp 3dB Input impedance Y : 75Input voltage C : 300mVpp 3dBInput impedance C : 751.3.4 Out 1Component Video Cinch Y/Pb/Praccording EIO-770-I-A, EIA-770-2Audio - CinchOutput vo

7、ltage : 2Vrms max.Output impedance : 10k1.3.5 Out 2Audio - CinchOutput voltage : 2Vrms max.Output impedance : 10kVideo - CinchOutput voltage : 1Vpp 3dB Output impedance : 75Video - YC (Hosiden)According to IEC 933-5Superimposed DC-level on pin 4 (load 100k)3.5V is detected as 16:9 aspect ratioOutput

8、 voltage Y : 1Vpp 3dB Input impedance : 75Output voltage C : 300mVpp 3dBInput impedance : 751.4 Digital Inputs / Outputs 1.4.1 Digital OutputDigital Audio Coaxial / OpticalLCM : according IEC 60958MPEG 1, MPEG 2, AC3 : according IEC 61937DTS : according IEC 61937 + addendum1.4.2 Digital Video Input

9、(IEEE 1394)Implementation Standard according:IEEE Std 1394-1995 IEC61883 - Part1IEC61883 - Part 2 SD-DVCR (02-01-1997)Specication of consumer use digital VCRs using 6.3mm magnetic tape dec.1994Mechanical connection according to Annex of IEC 61883-11.5 Video PerformanceAll outputs loaded with 75SNR m

10、easurements over full bandwidth without weighting.1.5.1 SCART (RGB)SNR : 55dB on all outputBandwidth : 4.8MHz -3dB1.6 Audio Performance 1.6.1 Cinch Output RearOutput voltage 2 channel mode : 2Vrms 1dBChannel unbalance (1kHz) : 110dBCrosstalk 16Hz-20kHz : 100dBFrequency response 20Hz-20kHz : 0.2dBSig

11、nal to noise ratio (unweighted) : 85dBCrosstalk 16Hz-20kHz : 70dBFrequency response 20Hz-20kHz : 0.5dBSignal to noise ratio (unweighted) : 80dBDynamic range 1kHz : 75dBDistortion and noise 1kHz : 75dBDistortion and noise 16Hz-20kHz : 50dBIntermodulation distortion : 70dBMute : 80dB1.7 Dimensions and

12、 WeightHeight of feet : 5.5mmApparatus : WxDxH:435x322x43mmWeight without packaging : 3kgWeight with packaging : 4kgEN 4 3139 785 320601. Technical Specications and Connection Facilities1.8 Laser Output Power & Wavelength1.8.1 DVDOutput power during reading : 0.8mWOutput power during writing : 20mWW

13、avelength : 650nm1.8.2 CDOutput power : 0.3mWWavelength : 780nm1.9 Read / Write SpeedType of Disc (Function) Disc Rotation SpeedRead Speed CD 7X CAV Read Speed DVD 4X CAV Write Speed DVD+R/+RW 2.4X ZCAVWrite Speed DVD-R/-RW 2X 1.10 PlayabilityDVDR3360HVideo Playback1. Disc Media:CD-R/-RW, MP3-CD, VC

14、D/SVCD,DVD-Video, DVD+R/+RW, DVD-R/-RW,DVD+RL DLx2. Compression Format:MPEG1, MPEG2DivX 3.11, DivX 4.x, DivX 5.x, DivX 6.0xAudio Playback1. Disc Media:CD, CD-R/-RW, MP3-CDx2. Compression Format:Dolby Digital, MP3, MPEG2 Multi-channel, AAC, WMAx3. MP3 bit rates: 32-256 kbps and VBRxStill Picture Play

15、back1. Disc Media:Picture CDx2. Picture Compression Format:JPGxEN 53139 785 32060 2.Test Disc & Repair Hints2. Test Disc & Repair Hints2.1 Test Disc1) 7104 099 96611 CD-RW printed Audio Disc2) 9965 000 25728 DVD Player Test Pack3) - Blank DVD+RW4) - Blank DVD-RW2.2 Open the DVD Tray manuallyNote: Th

16、is procedure needs to be performed on condition that:- a customers Disc is jammed in the DVD Tray- the DVD Tray cannot be open via the normal open/close button on the set.1) Place the set on the table with the bottom faced upwards as shown below.2) Insert a screw driver into the slot and open the DV

17、D Tray by sliding the screw driver in the direction shown.Figure 2-112EN 6 3139 785 320603. Firmware Upgrading3. Firmware Upgrading 3.1 Firmware UpgradingA. Preparation to upgrade rmware:1. Unzip the zip-archive le2. Start the CD Burning software and create a new CD project (data disc) with the foll

18、owing settings: File system : JolietFormat : MODE 2: CDROM XARecording mode : SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CDNote: Long le name is necessary for the preparation of the upgrade disc3. Place the content of the zip-archive into the root directory of the new CD project.4. Burn the data onto

19、 a blank CDR or CD-RWB. Procedure to apply the rmware upgrade:1. Power up the set and press buttons down.2. Close the tray and set will display:FLASH 13. The OSD Display.“Disc Upgrade - Software Upgrade Disc detected .Select OK to start upgrading or CANCEL to exit.”Press OK and the set will display:

20、ERASE WRITE.VERIFYThe OSD Display “Software Upgrade.Please wait.Do not switch off the power.”The loader software will also upgrade.OSD display “Loader software Upgrade Upgrading software.Please wait.Do not switch off the power.”Note: When the screen display “Verify”, the progress bar stays at 80% fo

21、r 5 minutes and do not switch off the power ,or the set will be defective.The whole process takes less than 15 minutesNote: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes defective.4. When the upgrade is completed the tray will open

22、 automatically and the set will display:“Loader upgrade process have completed successfully.Press OK to reboot system.”5. The tray open and the set will display:DONE 6. Press OK and the set will go into Standby mode.C. How to read out the rmware version to conrm set has been upgraded:1. Power up the

23、 set.and ensure no disc in the disc tray.2. Press button on the Remote control3. Press in the proper sequence4. Press and the screen will displayFirmware Information Build 5019V07 010 / Date:12 Apr 2006Loader Version 43.03.10Macrovision Version:MPEG Chip ID:Audio DAC:Region Num: 2 Developer: Philips

24、 PS3360H_31_R19.075. Press button and to exit.EN 73139 785 32060 4.Service Flow Chart4. Service Flow Chart4.1 Start ProcessStartA(VerificationTest)Is it a Hardwareproblem ?Upgrade to latest FirmwareIs it a knowncomplaint ?Is Firmware solutionavailable ?YesNoYesNoYesNoIs the complaintsolved ?Return s

25、et to Customer with YesNoReport on action doneSend refurbished set from pool stock to Trade / customerIs the complaintdocumented ?YesNoService W/S to contact the Trade / Customer to work out a action plan.Examples:- explain them that the Firmwaresolution is not ready- Upgrade disc will be sendto the

26、m the moment solutionis ready- etc.- Attached a Defect Description Reportand Proof of Purchase.- Pack defective set.- Store defective set for pick-up.EN 8 3139 785 320604. Service Flow Chart4.2 Verication Process* If complaint is related to Setup Menu settingConnect up the Recorder to TV antenna, TV

27、 set and an External sourceCheck the Firmware version on the setCan the set Start-up ?YesNoA(VerificationTest)BRecordingCheckCPlaybackCheckD *Setup MenuAre the checks result ok ?YesNoReturn set to Customer with Report on action doneSend refurbished set from pool stock to Trade / customer- Attached a

28、 Defect Description Reportand Proof of Purchase.- Pack defective set.- Store defective set for pick-up.NoYesIs Firmware the last released version ?Upgrade to latest FirmwareEN 93139 785 32060 4.Service Flow Chart4.3 Recording ProcessDVDR3360H Eur verification process_final.xlsTest disc:Blank DVD+RWM

29、anual Recording with TSB Blank DVD-RW Manual RecordingCopy to DVD Recordable disc Timer RecordingDoes Timer recordingfunctions ?YesNoDoes manual recordingNofunctions ?YesBRecordingCheckMake a Timer recording to the HDD or Recordable DVD with:- VPS/PDC on and off- Show View System- manual recordingPl

30、ayback the recorded titleAre Timer edit & delete feature working ?YesNoMake a manual recording to the HDD or Recorderable DVD using different recording source:- Cam 1 (Front CVBS)- Cam 2 (Front S-Video)- DV-in- Tuner- Rear Ext 1/2 (external CableBox/Satellite Receiver/VCR/DVD)Playback the recorded t

31、itleDoes theTSB feature works ?1) Switch the Recorder to Tuner source- The active Tuner channel will berecorded into the TSB (time shiftbuffer), a temporary HDD storagearea.2) By pressing the “INFO“ button theTime shift bar appears on the screen,check the following features:- search forward / backwa

32、rd- instant replay, pause, etc. on thelive TV function1) Make a short recording by selecting aportion in the TSB to be recorded.2) Playback the recorded title from theHDD Content MenuDoes the recordingfunctions ?ContinueContinueYesNoYesNoSend refurbished set from pool stock to Trade / customer- Atta

33、ched Defect Description Report andProof of Purchase.- Pack defective set- Store defective set for pick-up1) Insert a Recordable DVD2) In the HDD Content Menu select therecorded title and copy to recordableDVD3) Playback the copied titleDoes copy function ?YesNoRecordingEN 10 3139 785 320604. Service

34、 Flow Chart4.4 Playback ProcessTest disc:DVD Player Test Pack (12NC: 9965 000 25728)CD-RW Printed Audio disc (12NC: 7104 099 96611)Any Pre-recorded DVD+RWEdit Recordings on the HDD / Recordable DVD Play a Test discYesNoCPlaybackCheck1) Playing the DVD video disc andcheck the following:- T/C option-

35、INFO option- pause & search functions- change another title, chapter ortrack- zoom featureNote: Features are dependent on thekind of DiscYesNo Does the set work ?Does the edit featuresworks ?From the HDD Content Menu check the following Title edit features:- Edit, Divide, Delete, Rename, Lockand Pro

36、tectDoes the set work ?ContinueContinueYesNoSend refurbished set from pool stock to Trade / customer- Attached a Defect Description Reportand Proof of Purchase.- Pack defective set.- Store defective set for pick-up.Playing other type of disc:1) Use discs of DVD PLAYER TEST PACK for:- (Super) Video C

37、D- MP3 disc- Picture disc (slide show)- special DVD playback check by layer change test usingDVD disc of this package2) DivX3) For AUDIO CD use of CD-RW printed Audio Disc to check:- Track 3 finger print- Track 8: 600u black dot (max. after 1 min.)Does the edit featuresworks ?From the DVD Disc Menu check the following features:1) Disc Editing menu:- Rename, Erase, Overwrite, Finalizeor Lock disc- Record New Title2) Title Editing menu:- Edit, Rename, Erase, Append orOverwrite title- Overwrite discYesNo