Philips-FWR-7-Service-Manual电路原理图.pdf

《Philips-FWR-7-Service-Manual电路原理图.pdf》由会员分享，可在线阅读，更多相关《Philips-FWR-7-Service-Manual电路原理图.pdf（88页珍藏版）》请在收音机爱好者资料库上搜索。

1、Location of printed circuit boards. . . . . . . . . . . . . . . . . . . 1-2Technical specification. . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1Measurement setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2RC-5 codes. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2、 . . . . . . . 2-3Brief operating instructions. . . . . . . . . . . . . . . . . . . . . . . . 2-4Warnings for 2-digit numbers, press the keys in rapid succession) to select a track number.5Press YES to store your selection in the memory.yThe number of programmed tracks (STEP), Progand thetotal progr

3、am time are displayed. Thetrack numberblinks in the music calendar.6Select and store all desired tracks in this way.7Press PROG on the unit (PROGRAM on the remote control) to end programming. yPROGstays shown and the program is currently available.Note: If the maximum number of programmable tracks i

4、sreached, the display shows Programfull.1If necessary, press STOP &on the unit (on the remotecontrol) to stop playback.2Press either CD 1, CD 2, CD 3, or CDR to select the desired memory.3Press PROG (PROGRAM on the remote control), followed by !SEARCHorSEARCH(oron the remotecontrol) to move through

5、the program steps. yThe track number at the selected step and the total program time are displayed.4Press NO to remove the track from the program. yClearedis displayed briefly.yThe next programmed track number will move up to this position and is displayed together with the step number and the remai

6、ning total program time.1If necessary, press STOP &on the unit (on the remotecontrol) to stop playback.2Press NO. yClearProg?is displayed.3Press YES to clear the program. yProgClearedwill be displayed and PROGgoes off.Note: When you open the CDrecorder tray or the CD changertray the respective progr

7、am will be cleared.1Select and store all desired tracks in the CD changer memory (see “Programming track numbers”).2Enter the recording menu (see “Internal recording”).If the total time of the program is of larger size than the remaining recording time of the CDR(W): yNotfitting!will be displayed br

8、iefly, followed bythe remaining recording time and RecordProg?If you nevertheless start recording, only those tracks of the program that fit onto the CDR(W) will be recorded in entirety.To change the program, press NO. yEditProgramwill be displayed briefly, PROGand thetime of the program start blink

9、ing. Now you can change the program (see “Programming track numbers”, “Erasing a track from the program” and “Clearing the program”).Making a program for recordingClearing the programErasing a track from the programProgramming track numbersEnglishJOGCONTROLTRACKTXTRECLEVELSEARCHEDTPROGERCHFNALZEERASERECTYPECDCDCOMPLECDRECORDMASERVOMEPURELOUDNESSNCREDBLELYAUESTOPNOYS