Pioneer-SX315-rec-sm维修电路原理图.pdf

《Pioneer-SX315-rec-sm维修电路原理图.pdf》由会员分享，可在线阅读，更多相关《Pioneer-SX315-rec-sm维修电路原理图.pdf（56页珍藏版）》请在收音机爱好者资料库上搜索。

1、 ORDER NO. PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01

2、, Singapore 159936 PIONEER CORPORATION 2005 ? STANDBY/ON PHONES AUTOSURROUNDSTEREO STATIONCLASSFM/AMTAPE/VCRTV INPUT SELECTOR STBDVD/DVR DOWNUP MASTER VOLUME AUDIO MULTI-CHANNEL RECEIVER DIGITAL+ + SYSTEM SETUP TUNER EDIT CHANNEL LEVEL SOUND MODE OFFENTERTONE SOUND MODE TUNING SX-315 SX-315 RRV3071

3、AUDIO MULTI-CHANNEL RECEIVER SX-315 THIS MANUAL IS APPLICABLE TO THE FOLLOWING MODEL(S) AND TYPE(S). ModelTypePower RequirementRemarks SX-315KUCXCNAC120V For details, refer to Important Check Points for Good Servicing . T-ZZR FEB. 2005 printed in Japan RadioFans.CN 收音机爱 好者资料库 SX-315 2 1234 1234 C D

4、F A B E SAFETY INFORMATION This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer. Qualified technicians have the necessary test equipment and tools,and have been trained to properly and safely repair complex products such as those covered

5、by this manual. Improperly performed repairs can adversely affect the safety and reliability of the product and may void the warranty If you are not qualified to perform the repair of this product properly and safely you., should not risk trying to do so and refer the repair to a qualified service t

6、echnician. WARNING This product contains and certain electrical parts contain chemicals which are known to the state of California to cause cancer, birth defects or other reproductive harm. This product contains mercury. Disposal of this material may be regulated due to evironmental considerations.

7、For disposal or recycling information, please contact your local authoritier of the Electronice Industries Alliance : www.eiae.org. Health & Safety CodeSection 25249.6 Proposition 65 NOTICE (FOR CANADIAN MODEL ONLY) Fuse symbols (fast operating fuse) and/or (slow operating fuse) on PCB indicate that

8、 replacement parts must be of identical designation. REMARQUE (POUR MODLE CANADIEN SEULEMENT) Les symboles de fusible (fusible de type rapide) et/ou (fusible de type lent) sur CCI indiquent que les pices de remplacement doivent avoir la mme dsignation. ANY MEASUREMENTS NOT WITHIN THE LIMITS OUTLINED

9、 ABOVE ARE INDICATIVE OF A POTENTIAL SHOCK HAZARD AND MUST BE CORRECTED BEFORE RETURN- ING THE APPLIANCE TO THE CUSTOMER. 2. PRODUCT SAFETY NOTICE Many electrical and mechanical parts in the appliance have special safety related characteristics. These are often not evident from visual inspection nor

10、 the protection afforded by them necessarily can be obtained by using replacement components rated for voltage, wattage, etc. Replacement parts which have these special safety characteristics are identified in this Service Manual. Electrical components having such features are identified by marking

11、with a on the schematics and on the parts list in this Service Manual. The use of a substitute replacement component which does not have the same safety characteristics as the PIONEER recommended replacement one, shown in the parts list in this Service Manual, may create shock, fire, or other hazard

12、s. Product Safety is continuously under review and new instructions are issued from time to time. For the latest information, always consult the current PIONEER Service Manual. A subscription to, or additional copies of, PIONEER Service Manual may be obtained at a nominal charge from PIONEER. (FOR U

13、SA MODEL ONLY) 1. SAFETY PRECAUTIONS The following check should be performed for the continued protection of the customer and service technician. LEAKAGE CURRENT CHECK Measure leakage current to a known earth ground (water pipe, conduit, etc.) by connecting a leakage current tester such as Simpson M

14、odel 229-2 or equivalent between the earth ground and all exposed metal parts of the appliance (input/output terminals, screwheads, metal overlays, control shaft, etc.). Plug the AC line cord of the appliance directly into a 120V AC 60 Hz outlet and turn the AC power switch on. Any current measured

15、must not exceed 0.5 mA. Device under test Leakage current tester Earth ground Reading should not be above 0.5 mA Also test with plug reversed (Using AC adapter plug as required) Test all exposed metal surfaces AC Leakage Test RadioFans.CN 收音机爱 好者资料库 SX-315 3 5678 56 7 8 C D F A B E Important Check P

16、oints for Good Servicing In this manual, procedures that must be performed during repairs are marked with the below symbol. Please be sure to confirm and follow these procedures. 1. Product safety Please conform to product regulations (such as safety and radiation regulations), and maintain a safe s

17、ervicing environment by following the safety instructions described in this manual. 1 Use specified parts for repair. Use genuine parts. Be sure to use important parts for safety. 2 Do not perform modifications without proper instructions. Please follow the specified safety methods when modification

18、(addition/change of parts) is required due to interferences such as radio/TV interference and foreign noise. 3 Make sure the soldering of repaired locations is properly performed. When you solder while repairing, please be sure that there are no cold solder and other debris. Soldering should be fini

19、shed with the proper quantity. (Refer to the example) 4 Make sure the screws are tightly fastened. Please be sure that all screws are fastened, and that there are no loose screws. 5 Make sure each connectors are correctly inserted. Please be sure that all connectors are inserted, and that there are

20、no imperfect insertion. 6 Make sure the wiring cables are set to their original state. Please replace the wiring and cables to the original state after repairs. In addition, be sure that there are no pinched wires, etc. 7 Make sure screws and soldering scraps do not remain inside the product. Please

21、 check that neither solder debris nor screws remain inside the product. 8 There should be no semi-broken wires, scratches, melting, etc. on the coating of the power cord. Damaged power cords may lead to fire accidents, so please be sure that there are no damages. If you find a damaged power cord, pl

22、ease exchange it with a suitable one. 9 There should be no spark traces or similar marks on the power plug. When spark traces or similar marks are found on the power supply plug, please check the connection and advise on secure connections and suitable usage. Please exchange the power cord if necess

23、ary. 0 Safe environment should be secured during servicing. When you perform repairs, please pay attention to static electricity, furniture, household articles, etc. in order to prevent injuries. Please pay attention to your surroundings and repair safely. 2. Adjustments To keep the original perform

24、ance of the products, optimum adjustments and confirmation of characteristics within specification. Adjustments should be performed in accordance with the procedures/instructions described in this manual. 4. Cleaning For parts that require cleaning, such as optical pickups, tape deck heads, lenses a

25、nd mirrors used in projection monitors, proper cleaning should be performed to restore their performances. 3. Lubricants, Glues, and Replacement parts Use grease and adhesives that are equal to the specified substance. Make sure the proper amount is applied. 5. Shipping mode and Shipping screws To p

26、rotect products from damages or failures during transit, the shipping mode should be set or the shipping screws should be installed before shipment. Please be sure to follow this method especially if it is specified in this manual. RadioFans.CN 收音机爱 好者资料库 SX-315 4 1234 1234 C D F A B E CONTENTS SAFE

27、TY INFORMATION.2 1. SPECIFCATIONS .5 2. EXPLODED VIEWS AND PARTS LIST.8 2.1 PACKING .8 2.2 EXTERIOR SECTION.10 2.3 FRONT PANEL SECTION .12 3. BLOCK DIAGRAM AND SCHEMATIC DIAGRAM.14 3.1 BLOCK DIAGRAM.14 3.2 OVERALL WIRING CONNECTION DIAGRAM.16 3.3 MAIN, PROTECTION and POWER ASSYS .18 3.4 DSP ASSY.20

28、3.5 CNT1, CNT2, FRONT, SW AMP, ST-BY TACT and H/P ASSYS.22 4. PCB CONNECTION DIAGRAM .24 4.1 MAIN ASSY .26 4.2 PROTECTION ASSY.28 4.3 POWER ASSY.29 4.4 DSP ASSY.30 4.5 CNT1 and CNT2 ASSYS .32 4.6 FRONT, SW AMP, ST-BY TACT and H/P ASSYS .34 5. PCB PARTS LIST .38 6. ADJUSTMENT .42 6.1 IDLE ADJUSTMENT.

29、42 7. GENERAL INFORMATION.43 7.1 DIAGNOSIS.43 7.1.1 TROUBLE SHOOTING.43 7.1.2 PCB LOCATION .45 8. PANEL FACILITIES .53 8.1 FRONT PANEL SECTION .53 8.2 DISPLAY .54 8.3 REMOTE CONTROL .55 RadioFans.CN 收音机爱 好者资料库 SX-315 5 5678 56 7 8 C D F A B E 1. SPECIFCATIONS Amplifier section Continuous Power Outpu

30、t Front . . . 100 W per channel *(200 Hz 20 kHz, 1.0%*, 6 ) Center . . . . . . . . . . . . 100 W *(200 Hz 20 kHz, 1.0%*, 6 ) Surround . . . . . . . 100 W per channel *(200 Hz 20 kHz, 1.0%*, 6 ) Subwoofer . . . . . . . . . .100 W *(45 Hz 200 Hz, 1.0%*, 6 ) RMS Power Output Front . . . . . . . . . 125

31、W per channel (1kHz, THD 10%, 6 ) Center . . . . . . . . . . . . . . . . . .125W (1kHz, THD 10%, 6 ) Surround . . . . . 125W per channel (1kHz, THD 10%, 6 ) Subwoofer . . . . . . . . . . . . . . 125W (100Hz, THD 10%, 6 ) Music Power Output Front . . . . . . . 167 W per channel (DIN MUSIC, 10%, 6 ) C

32、enter . . . . . . . . . . . . . . . .167 W (DIN MUSIC, 10%, 6 ) Surround . . . 167 W per channel (DIN MUSIC, 10%, 6 ) Subwoofer . . . . . . . . . . . . . 167 W (DIN MUSIC, 10%, 6 ) * Measured pursuant to the Federal Trade Commissions Trade Regulation rule on Power Output Claims for Amplifiers. * Mea

33、sured by audio spectrum analyzer. FM Tuner Section Frequency Range . . . . . . . . . . . . . . . 87.5 MHz to 108 MHz Antenna Input (DIN). . . . . . . . . . . . . . . . . .75 unbalanced AM Tuner Section Frequency Range 10kHz step . . . . . . . . . . . . . . . . . . . . .530 kHz to 1,700 kHz Antenna .

34、 . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loop antenna Miscellaneous Power requirements . . . . . . . . . . . . . . . . .AC 120 V / 60Hz Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . 200W In standby . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

35、. . .0.5W Dimensions . . . . . . . . . . . . . . 16.5 (W) x 6.2 (H) x 15.7 (D) in. 420 (W) x 158 (H) x 400 (D) mm Weight (without package) . . . . . . . . . . . . . . . . . . 20 lb 15 oz 9.5 kg Furnished Parts AM loop antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wi

36、re antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Dry cell batteries (AA size IEC R6) . . . . . . . . . . . . . . . . . . 2 Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty card . . . . . . . . . . . . . . . . . . . . . .

37、. . . . . . . . . . . . . . 1 Operating instructions Note Specifications and the design are subject to possible modifications without notice, due to improvements. Specifications RadioFans.CN 收音机爱 好者资料库 SX-315 6 1234 1234 C D F A B E RECEIVER + + + + BASS OFFSOUNDTONE MPX AUTO ROOM SETUP TEST TONE SYSTEM SETU H LEVEL TUNINGSTATION FM/AM TAPE/VCRTVCLASS DIGITAL INPU