DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf

上传人:cc518 文档编号:299581 上传时间:2026-02-26 格式:PDF 页数:2 大小:634.29KB
下载 相关 举报
DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf_第1页
第1页 / 共2页
DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

《DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf》由会员分享,可在线阅读,更多相关《DeWald-Radio-Mfg-Corp-E-522 电路原理图.pdf(2页珍藏版)》请在收音机爱好者资料库上搜索。

1、MANUAL OF 1951 MOST-OFTEN-NEEDED RADIO DIAGRAMS Alignment Instructions for DeWald Radio Model E-520 (Circuit Diagram on page 25) To calibrate Model E-520 receiver, connect the output of a signal generator in series with a 200 mmfd. fixed condenser to the flexible antenna lead attached to the loop. C

2、onnect the low side of the generator through a 0.1 mfd. condenser to the receiver chassis. The wave band switch should be in the broad cast position. Adjust the generator to 455 KC. and adjust both I.P. transformers (both top and bottom) for maximum signal out put. Open the variable condenser for mi

3、nimum capacity. Turn the wave band switch to short wave ,fl position. Set generator at 24.2 MC. Peak the short wave $1 oscillator trimmer screw (C5) for maximum signal. Next set the generator at 25 MC. and tune in this signal on receiver. Adjust short wave #1 R.F. trimmer screw (C2) for maximum sign

4、al. The low frequency end of the dial is automatically adjusted by a fixed padder conden ser. Next turn band switch to short wave #2 position. Rotate drive shaft until variable condenser of the receiver is open all the way. Adjust generator to 8 MC. Adjust the short wave #2 oscillator trimmer screw

5、(C4) until maximum signal is secured. Next set generator at 7 MC. Tune in this signal on receiver, and adjust short wave #2 R.F. trimmer screw (Cl) for maximum signal strength. The low frequency end of the dial is automa tically adjusted by a fixed padder condenser. Next turn band switch to broadcas

6、t position. Adjust generator to produce 1500 KC. and tune in this signal on receiver. Adjust the broadcast oscillator trimmer screw (C3) for maximum signal. To adjust the low end of the dial, set the generator and receiver at 600 KC. Peak the broadcast padder (C7) for maximum output. The variable condenser should be rocked slightly during this ope ration. Keep the signal generator output as low as possible - when making all these adjustments. PHONOGRAPH MOTOR 收音机爱 好者资料库 RadioFans.CN 收音机爱 好者资料库 RadioFans.CN

展开阅读全文
相关资源
猜你喜欢
相关搜索
资源标签

当前位置:首页 > 欧美收音机 > DeWald Radio Mfg. Corp

copyright@ 2008-2025 收音机爱好者资料库 版权所有
备案编号:鄂ICP备16009402-5号